2 mate trumpf specials
TRANSCRIPT
( Max mtrl. thickness 2.7mm)
Max. height : 3.7mm from bottom of sheet to top of form
Ribs
Offsets
Mate Rollerball™
Mate Rollerball™
Rollerball Example
Rollerball® Beading in 1mm mild steel
Detail inside corner with Roller Ball
Mate Rollerball™
4
Mate Rollerball™
*Tool type 32-Hold down ram while moving sheet-Indexing is required
*Software option for “Wheel Technology” required in machine control
*With TOPS: only for machines TC500 and later
*OK to program with JETCAM, WICAM (but machine must be compatible!)
5
MATE Deburr Rollerball®
• Remove burrs during the punching process
• Eliminates secondary deburring operations
• Press must be capable of holding the ram down while the sheet is moved in the X and or Y direction.
• Every possible part contour, even small corners– Up to 4.0mm, all kinds of
steel
6
ROLLERBALL DEBURR
7
MATE Deburr Rollerball® ®
*Tool type 33-Hold down ram while moving sheet-Indexing not required
* Software option “Carver” required in machine control
*With TOPS: only for machines TC500 and later
*OK to program with JETCAM, WICAM (but machine must be compatible!)
VIDEO: Deburring Tool in combination with EasySnap
MATE Deburr Rollerball®
9
MATE Sheetmarker™
• Programmable marking• Plastic foil cutting• Press must be capable of
holding the ram down while the sheet is moved in the X and or Y direction.
P127389Z
P127389ZXYZ Company
XYZ Company
Can be run at up to 90 m/min
MATE Sheetmarker™
Score Plastic Protection for removal before laser cutting or fabrication ( bending lines etc.)
Cuts trough the protective plastic film without leaving any marks on the metal surface.
MATE Sheetmarker™
12
*Tool type 33-Hold down ram while moving sheet-Indexing not required
* Software option “engraving technology” required in machine control
*With TOPS: only for machines TC500 and later
*OK to program with JETCAM, WICAM (but machine must be compatible!)
MATE Sheetmarker™
Self-locking spring loaded tab
Eliminates spot welding, riveting or fastening with threaded hardware
MATE SnapLock™
MATE SnapLock™
MATE SnapLock™
16
Tool type 13:
- Forming tool
MATE SnapLock™
MATE EasySnap™
V-line stencil from both sides creates snap-line
USE: better than microjoint – can be snapped-off
TYPICAL APPLICATION:
– Material thickness from 1.0mm thick
to 1.5mm MS and SS, and 2.0mm ALU
– Tool dedicated for 1 thickness only
– Max. recommended length 300mm
USE: small internal bends that are not possible or hard to do with a press brake
CAN REPLACE line of small round or rectangle holes for easy hand-bending
TYPICAL APPLICATION:
– Material thickness from 1.0 mm to 2.0 mm
– Tool dedicated for 1 thickness
MATE EasyBend™
MATE EasySnap™
19
Making short bends on a press is now possible with an EasySnap
20
Triple bridge
Positive retention
Common size bolts
Robust easy to use tooling
MATE HexLock
21
Progressive Tools
22
Progressive Tools
23
Progressive Tools
EasyView Dies
Piercing and Forming Clusters
Piercing and Forming Clusters
MATE WEBTOOL
- Produces reinforcement ribs with a hexagonal design- Allows to use thinner material and save material cost, yet maintaining the same strenght in the product.
Save on material cost