5.creo+chamfers
TRANSCRIPT
-
8/13/2019 5.Creo+Chamfers
1/1
Creo 1.0 Parametric Reference page:Chamfers
1. Select the chamfer icon from the top menu2. Select an edge on the solid part - hold CTRL to add further edges to the set3. D x D is default for equal sizes of chamfer.4. Use white drag handles to get the sizes D1 and D2 (or enter in the boxes above after selecting type)5. Save the part
JM April 2012
Transition modeSet mode
Preview
Cancel
Right click for this menu or
select type from dashboard
Interchange D1 and D2
For advanced users: transitions
can be set up by using datum lines
or points when O x O sizing is used
so that a chamfer can be stopped
at a point
Apply
Dimension 2Dimension 1
Chamfer type