chapter 14 solutions. 14.1 what are solutions? complete the graphic organizer: matter, substance,...
Post on 18-Dec-2015
225 Views
Preview:
TRANSCRIPT
CHAPTER 14Solutions
14.1 WHAT ARE SOLUTIONS?
Complete the graphic organizer: matter, substance, element, compound, mixture, homogeneous(solution), heterogeneous.
Characteristics of Solutions
Solutions are homogenous mixtures containing two or more substances called the solute and the solvent.
The solute is the substance that dissolves.
The solvent is the dissolving medium. Aqueous solutions are water samples
containing dissolved substances. Ex) salt water
Characteristics of Solutions Cont. Soluble describes a substance that can
be dissolved in a given solvent. Opposite: insoluble
Miscible describes two liquids that are soluble in each other. Opposite: immiscible
Type of Solution
Example Solvent Solute
Gas in gas Air Nitrogen Oxygen
Gas in liquid Soda Water Carbon Dioxide
Liquid in liquid Vinegar Water Ethylene glycol
Solid in liquid Ocean water Water Sodium chloride
Solid in solid Steel Iron Carbon
Solutions Exist in ALL States of Matter
Solvation: “Like Dissolves Like”
Consider what happens when oil is poured into water. one is polar, one is nonpolar; they separate
and don’t mix (immiscible liquids) Polar solutes are soluble in polar
solvents. Nonpolar solvents dissolve nonpolar
solutes.
Properties of Solutions
Solubility is the amount of solute that will dissolve in a given amount of solvent A saturated solution contains the maximum
amount of solute for a given amount of solvent at a constant temperature.
An unsaturated solution contains less solute than a saturated solution.
A supersaturated solution contains more than the maximum amount of solute in a saturated solution (holds more than it theoretically should)
Musical Chair Saturation Analogy
When it the music stops, 6 kids try to sit in 5 chairs (supersaturated). The kids are uncomfortable, just as a supersaturated solution is comparatively unstable.
When the uncomfortable extra kid gets tired of being squeezed, she stands up and vacates the chairs. This is analogous to excess solute crystallizing out of a saturated solution.
Now the solution is saturated, with five kids and five chairs.
What would an unsaturated situation look like?
Factors affecting solubility
Solids (temperature) Gases (temperature and pressure) As a general rule, dissolved solid
solutions increase in solubility as temperature increases, but gases decrease as temperature increases.
Factors affecting solution process
Stirring Agitating Temperature Particle size THESE AFFECT RATE NOT AMOUNT
Henry’s Law
Henrys law: S1P2=S2P1
The ratio of solubility of a gas to the pressure is a constant. As pressure increases, solubility increases.
Practice Problem
If a gas has a solubility of 0.64 g/L at a pressure of 94.7 kPa, what will its solubility be at 103.5 kPa?
Homework
Solubility Curves Worksheet
14.2 SOLUTION CONCENTRATION
Molarity
A measure of concentration Concentration is the amount of solute that
is dissolved in a given quantity of solvent while saturation compares how much is dissolved to what can be dissolved.
Dilute concentration vs Concentrated
Molarity
Molarity is the number of moles of solute dissolved per liter of solution.
Dilutions with Molarity
Practice Problems
What is the molarity of a solution if 0.400 g CuSO4 are dissolved in enough water to make 4.00L of solution?
A student needs 250.0 mL of 3.00M HCl. The stock bottle says 12.0M. How much does she add?
Molality and Mole Fraction
Molality is another unit of concentration and divides the moles of solute by the kilograms of solvent.
Mole Fraction can be used to figure out how many moles of a substance are present in a solution.
Practice Problems
If 9.00 g oxalic acid (H2C2O4) are dissolved in 250.0 g of H2O, what is the molality of the solution?
What is the mole fraction of sucrose (C12H22O11) if 125.0g of sucrose are dissolved in 125g of H2O?
Percent Solutions
Percent by volume when both components are liquids, the one
with the largest volume is the solvent
Percent by mass
Practice Problems
What is the percent by volume of ethanol in the final solution when 85 mL of ethanol is diluted to a volume of 250 mL with H2O?
How many grams of glucose would you need to prepare 2.0 L of 2.8% glucose solution?
Homework
Molarity, Molarity by Dilution, and Molality worksheets
14.3 COLLIGATIVE PROPERTIES OF SOLUTIONS
Colligative Properties
Colligative properties of a substance change due to having dissolved materials in it. (dissolved particles change the properties by “getting in the way”) Vapor pressure lowering Boiling point elevation Freezing point depression Osmotic pressure
Vapor Pressure
Solvent molecules form a shell around the solute, leaving fewer molecules to vaporize (lowers the vapor pressure)
Boiling Point Elevation
Additional kinetic energy must be added in order to raise the lowered vapor pressure of a solution to atmospheric pressure
Freezing Point Depression
Solute disrupts the formation of a solid (more kinetic energy must be withdrawn)
Adding salt to sidewalks (ice melts and forms a solution with a lower freezing point)
Colligative Properties
ΔTb = Kbmi
ΔTf = Kfmi where i is equal to the number of ions in the
formula for an ionic compound K2SO4 i=3 (2 K+ and 1 SO4
2-)
m is molality K is a constant for boiling or freezing.
Practice Problems
What are the boiling and freezing points of a solution made by dissolving 75.0g NaCl in 500.0g of H2O?
Osmotic Pressure
Osmosis is the diffusion of solvent particles across a semipermeable membrane from an area of higher solvent concentration to an area of lower solvent concentration. Semipermeable membranes are barriers with tiny pores
that allow some but not all kinds of particles to cross. Example: kidney dialysis, uptake of nutrients by plants.
Osmotic Pressure is the amount of additional pressure caused by the water molecules that moved into the solution. Dependent upon the number of solute particles in a
given volume of solution.
Homework
Effect of a Solute on Freezing and Boiling Points Worksheet
14.4 HETEROGENEOUS MIXTURES
14.4 Heterogeneous Aqueous Mixtures
Solutions are homogenous mixtures (the same throughout, extremely small particles).
Colloids have intermediate sized particles that do not settle out but are too big to be a solution (can be seen under a microscope). Ex. Paint, gelatin, milk (emulsions are liquid-
liquid colloids) Suspensions are mixtures from which
particles settle out upon standing (large particles). Can clearly identify two or more substances
(muddy water)
Properties of Colloids
The random movement of colloidal sized particles which keeps them from settling is called Brownian Motion.
The scattering of light by colloid or suspension sized particles is called the Tyndall effect. You can see a beam of light passed through
a colloid, like a sunbeam in a dusty room or headlights through a fog.
top related