coupled chaotic system based on shinriki-mori...
Post on 21-Jan-2021
2 Views
Preview:
TRANSCRIPT
Coupled Chaotic System Based on Shinriki-Mori Circuit
Tatsuki Sobue1, Yasuteru Hosokawa1 and Yoshifumi Nishio2
1 Shikoku UniversityFurukawa, Ohjin, Tokushima, Japan
Phone:+81-88-665-1300FAX:+81-88-637-1318
E-mail: s002337018@edu.shikoku-u.ac.jpE-mail: hosokawa@keiei.shikoku-u.ac.jp
2 Tokushima University2-1 Minami-Josanjima, Tokushima, Japan
Phone:+81-88-656-7470FAX:+81-88-656-7471
E-mail: nishio@ee.tokushima-u.ac.jp
Abstract
Shinriki-Mori circuit have been applied to coupled systemsfor investigations of a coupled system. In this study, we pro-pose a novel coupled system based on Shinriki-Mori circuit.
1. Introduction
There are many studies about synchronization phenomenaof coupled chaotic circuits. In these system, some famouschaotic circuits are applied. One of famous chaotic circuitis Shinriki-Mori circuit [1] [2]. There are many investiga-tions about coupled chaotic circuits using this circuit. Oneof important factors is a parameter mismatch in these inves-tigations. By including a parameter mismatches, some inter-esting phenomena are observed. In the first place, the circuitincludes parameter mismatches. There are not perfectly sametwo things in the natural world.
However, it is not easy to change a circuit characteristicintentionally by changing parameter mismatches. Especially,switching phenomena which are very interesting phenomenaare influenced by a parameter mismatches.
In this study, a novel coupled system for investigation ofcoupled chaotic system is proposed. This system can gener-ate similar two chaotic waveforms intentionally. This systemis also a coupled chaotic system. By investigating this sys-tem, the contribution of the field of coupled chaotic circuits isexpected.
2. Circuit Model
Figure 1 shows a proposed circuit. This system is basedon Shinriki-Mori circuit proposed in [1]. The modified pointsare follows. Right parts of the circuit are duplexed. Resis-tors Rn (n = 1, 2, · · ·N ) are added for changing a parameterof bidirectionally coupled diodes. In this study, bidirection-ally coupled diodes and resistors are modeled as a piecewiselinear function shown in Fig. 2.
v 1
v 2
vC
i 1
i 2
1L
2L2R
1R
CR
f (v - v )1C
vN
i N
NLNR
1C
2C
CC
NC
th
f (v - v )2Cth
f (v - v )NCth
Figure 1: Proposed System.
Using this model, the circuit equation is described as fol-lows.
Cndvndt
=vcRn
− fth(vc − vn)− in,
Ccdvcdt
=vcRc
−N∑
n=1
αnfth(vc − vn) ,
Lndindt
= vn,
(1)
where
f(v) = v + (|v − Vth| − |v + Vth|)/2. (2)
- 529 -
2014 RISP International Workshop on Nonlinear Circuits,Communications and Signal ProcessingNCSP'14, Honolulu, Hawaii, USA. February 28 - March 3, 2014
v
i
(a) (b)i
v
1
1
1
1
(c)
Figure 2: Bidirectionally coupled diodes model. (a) Circuitschematic. (b) Circuit model. (c) v − i characteristic.
By substituting the variables and the parameters,
xn =vnVth
, xN+n =
√L1
C1
inVth
,
d
dt= “ · ”, τ =
1√L1C1
t, αn =1
Rn
√L1
C1,
αc =1
Rc
√L1
C1, βn =
C1
Cn, βc =
C1
Cc
and γn =L1
Ln, (n = 1, 2, · · ·N.)
(3)
equations (1) and (2) are normalized asxn = βn αnf(xc − xn)− xN+n ,
xN+n = γnxn,
xc = βc
[αcxc −
N∑n=1
αnf(xc − xn)
],
(4)
where
f(x) = x+ (|x− 1| − |x+ 1|)/2. (5)
3. Experimental Results and Computer Simulation Re-sults
At first, the case of N = 2 is investigated. Figure 3 showscircuit experimental results (a) and computer simulation re-sults (b)-(c). Parameters are set as R1 = R2 = 120 [Ω],C1 = C2 = 0.015[µF], L1 = L2 = 50[mH] in circuit ex-periments. α1 = α2 = 9, β1 = β2 = 1, βc = 0.32 andγ1 = γ2 = 1. Control parameters are selected as Rc. Figure 3
(a) show projections of attractors onto v3 − x1 plane. Fig-ures 3 (b) and (c) show projections of attractors onto v3 − x1
plane and v3 − x1 plane, respectively.By changing parameter Rc and αc, one periodic orbit (1),
two periodic orbit (2), chaos (3) (4), double scroll type attrac-tor (5), window (6) and chaos (7) are observed. In this investi-gation, parameters of right side elements are same. Therefore,v1 and v2 are synchronized as shown in Fig. 3 (c).
Figure 4-5 shows the case of applying different resistancesof the right side of the system. When differences are small asshown in Fig. 4, these are synchronized. However, by increas-ing the differences, these become asynchronization states asshown in Fig. 5. We consider that there are possibility ofapplying this state to some applications because these havesimilar waveforms in spite of the asynchronization state.
On the other hand, the case applying same resistance anddifferent capacitances of the right side of the system is shownin Fig. 6-7. In these cases, these are not synchronized at all.However, in the case of Fig. 6, waveforms and attractors arevery similar forms.
4. Conclusion
In this study, we propose a novel coupled system basedon Shinriki-Mori circuit. The relationships between observedsynchronization phenomena and parameters are investigated.
In the future works, the large number N case will be inves-tigated.
References
[1] M. Shinriki, M. Yamamoto and S. Mori, “Multimode Os-cillations in a Modified van der Pol Oscillator containinga positive nonlinear conductance,” Proc. IEEE, vol. 69,no. 3, pp. 394-395, 1981.
[2] N. Inaba, T. Saito and S. Mori, “Chaotic Phenomena ina Circuit with a Negative Resistance and an Ideal Switchof Diodes,” IEICE Trans., vol. E-70, pp. 744–754, 1987.
[3] H. Sekiya, S. Moro, S. Mori, and I. Sasase, “Synchro-nization Phenomena on Four Simple Chaotic OscillatorsFull-Coupled by Capacitors,” IEICE Trans. Fundamen-tals, vol. J82-A, No. 3, pp.375–385, 1999.
[4] M. Miyamura, Y. Nishio and A. Ushida, “Clustering inGlobally Coupled System of Chaotic Circuits,” IEEEProc. ISCAS’02, vol. 3, pp. 57–60, 2002.
[5] L. M. Pecora and T. L. Carrol, “Synchronization inChaotic Systems,” Physical Review Letters, vol. 64, pp.821–824, 1990.
- 530 -
(1)
Rc = 1.94k[Ω] αc = 0.40
(2)
Rc = 1.70k[Ω] αc = 0.60
(3)
Rc = 1.55k[Ω] αc = 0.80
(4)
Rc = 1.44k[Ω] αc = 1.0
(5)
Rc = 1.39k[Ω] αc = 1.05
(6)
Rc = 1.28k[Ω] αc = 1.33
(7)
Rc = 1.01k[Ω] αc = 1.40(a) (b) (c)
Figure 3: Circuit experimental results (left) and computer cal-culation results (center and right) (N = 2). R1 = R2 =[Ω],R3 =[Ω], C1 = C2 =[µF], Cc =[µF], α1 = 4, α2 = 9,β2 = β3 = 0.32, γ1 = γ2 = 1, (a) Projection of attractorsonto v3 − x1 plane. (b) Projection of attractors onto x3 − x1
plane. (c) Poincare sections. x1 − x2 plane.
(1)
(2)
(3)
(a) (b) (c)
Figure 4: Different capacitances case. C1 = 1.0 and C2 =1.0. (a) x3 − x1. (b) x3 − x2. (c) x1 − x2. (1) αc = 1.0. (2)αc = 1.1. (3) αc = 1.5.
(1)
(2)
(3)
(a) (b) (c)
Figure 5: Different resistance case. α1 = 4.0, α2 = 9.0,β2 = β3 = 0.32 and γ1 = γ2 = 1. (1) αc = 1.00. (2) αc =1.05. (3) αc = 1.60. (a) x3 − x1. (b) x3 − x2. (c) x1 − x2.
- 531 -
(1)
(2)
(3)
(a) (b) (c)
Figure 6: Different capacitances case. C1 = 1.1 and C2 = 1.(a) x3 − x1. (b) x3 − x2. (c) x1 − x2. (1) αc = 0.9. (2)αc = 1.1. (3) αc = 1.5.
(1)
(2)
(3)
(a) (b) (c)
Figure 7: Different capacitances case. C1 = 0.33 and C2 =1.0. (a) x3 − x1. (b) x3 − x2. (c) x1 − x2. (1) αc = 1.0. (2)αc = 1.2. (3) αc = 1.6.
- 532 -
top related