freelander 3.2

8/16/2019 Freelander 3.2

1/4

Connect as below:

Serial Suite: ECU Plug:

Red  to 2 Pins Red (Power Supply +12 Volt)Black to 2 Pins Black (Ground)

Piasiniengineering info@piasinienginnering.it – http://www.piasiniengineering.itTel: +39 0342 489060 - Fax: +39 0342 488298

mailto:info@piasinienginnering.ithttp://www.piasiniengineering.it/http://www.piasiniengineering.it/mailto:info@piasinienginnering.it

8/16/2019 Freelander 3.2

2/4

Where to connect the flat cable: 

Piasiniengineering info@piasinienginnering.it – http://www.piasiniengineering.itTel: +39 0342 489060 - Fax: +39 0342 488298

mailto:info@piasinienginnering.ithttp://www.piasiniengineering.it/http://www.piasiniengineering.it/mailto:info@piasinienginnering.it

8/16/2019 Freelander 3.2

3/4

READ the ECU:

Picture

1.  Connet the flat cable following the number in the picture;2.   You have to put 5 wire (bridge) like in the picture.

Piasiniengineering info@piasinienginnering.it – http://www.piasiniengineering.itTel: +39 0342 489060 - Fax: +39 0342 488298

mailto:info@piasinienginnering.ithttp://www.piasiniengineering.it/http://www.piasiniengineering.it/mailto:info@piasinienginnering.it

8/16/2019 Freelander 3.2

4/4

WRITE the ECU: 

 You have to remove bridge used before(picture 1), put other 2 wire(bridge) like in thepicture, the flat cable is still connect. 

Piasiniengineering info@piasinienginnering.it – http://www.piasiniengineering.itTel: +39 0342 489060 - Fax: +39 0342 488298