reaction kinetics

Reaction Kinetics

The Kinetic Theory of Matter

The Kinetic Theory of Matter states that matter is composed of a large number a small particles—individual atoms or molecules—that are in constant motion.

This constant motion is the reason that chemical reactions occur.

Kinetics Branch of chemistry that deals with

how fast reactions occur, Rates of Reactions.

NO(g) + F2(g) 2NOF(g)

The Reaction ProcessReaction Mechanism – chemical reactions

occur through a series of smaller (step-like) reactions called elementary steps.

Step 1: NO(g) + F2(g) NOF2 (g)Step 2: NOF2 (g) + NO(g) 2NOF(g)

Overall Reaction: NO(g) + F2(g) 2NOF(g)

The Reaction ProcessIntermediates – products in one step that

become reactants in a subsequent step (NOT Part of the overall reaction)

Catalysts – substances that appear as a reactant in one step and as a product in a subsequent step. (NOT part of the overall reaction). Catalysts are used to INCREASE the rate of a reaction but they do not affect the outcome of the reaction.

The Reaction ProcessRate determining step – the slowest

step in the reaction mechanism.

Homogeneous Reaction – reactants and products are in the same phase of matter.

Heterogeneous Reaction – reactants NOT in the same phase of matter.

Kinetic Theory of Matter All matter is in ______________ motion.

Collision Theory – collisions between particles must be in proper orientation and have sufficient energy for a chemical reaction to occur. Effective Collisions – result in products forming.

What are effective Collisions?

A) Collisions with proper orientation.B) Collisions with sufficient energy.

If A and B are not met ________________!!!!

Factors affecting the Rate of Chemical Reactions.

1. Reaction Mechanism2. Nature of Reactants3. Surface Area4. Concentration5. Pressure6. Temperature7. The presence of a catalyst

1. Reaction Mechanism The amount of steps within a reaction.

Step 1: A + B + D AB0.008mol/sec

Step 2: AB + C ABC0.004mol/sec

Step 3: C + A + B ABC + D0.010mol/sec

Overall: 2A + 2B + 2C 2ABC

1. Reaction Mechanism

Which step was the rate determining step? Step 2 at 0.004mol/sec (slowest step)

Which substance was the intermediate? AB (products in one step that become reactants in a

subsequent step, NOT part of the overall reaction)

Which substance was the catalyst? D (appears as a reactant in one step and as a product in

a subsequent step, NOT part of overall reaction.)

2. Nature of the Reactants Covalent Substances – react slowly

due to a greater number of bonds that must be broken before the reaction can occur.

Ionic Substances – react fast because ionic bonds are simply an attraction between positive and negative charges and no real bonds must to be broken.

2. Nature of Reactants If ions are already present, they react

the fastest!!!

Example: NaCl(aq) vs. CH4

Which one will react faster?___________

3. Surface Area The greater the surface area, the

faster the reaction. The lesser the surface are, the slower

the reaction.

Ex) Steel wool rusts faster than a piece of steel.

Ex)Wood chips burn faster than a log.

4. Concentration As concentration increases, the # of

reactant particles increases which leads to increased effective collisions.

As concentration decreases, the # of reactant particles decreases which leads to decreased effective collisions.

5. Pressure Only effect gases!!!! No effect on solids or liquids When pressure on a gas is

applied, there is less room (volume) which will lead to more effective collisions.

6. Temperature Increased temperature leads to

increased kinetic energy of particles, there more there is more chance for effective collisions to occur.

The hotter something gets the faster its particles move.

7. Catalysts Speed up a reaction. They speed up the reaction by lowering

the activation energy. (hill) Fast reactions have low activation

energy.

Energy Diagrams Shows the change in energy as a

chemical reaction occurs.

Vocabulary associated with energy diagrams

Activation Energy: energy needed to change reactants into products. (Energy needed to go up the hill.)

Activated Complex: a temporary, intermediate product that either re-forms into reactants or forms new products. (Point at the top of the hill.)

Heat of Reaction (∆H): heat energy emitted or absorbed when products form.

∆H = Hproducts - Hreactants

Energy DiagramsA. Potential Energy of ReactantsB. Activation Energy (PEactivated complex – Pereactants)

Activation Energy of the forward reactionC. Potential Energy of the Activated ComplexD. Potential Energy of the ProductsE. Heat of Reaction, ∆H (PEproducts – PEreactants)F. Activation Energy (PEactivated complex – PEproducts)

Activation Energy of the reverse reactionG. Activation Energy of forward reaction with a catalystH. Activation Energy of reverse reaction with a catalyst

-∆H = Exothermic reaction. Products have lower Potential Energy than reactant. Energy is released!!

+∆H = Endothermic reaction. Products have higher Potential Energy than reactants. Energy is absorbed!!

Catalyst: substance added to a reactistaon to speed it up by lowering activation energy (hill).

Inhibitor: substance added to a reaction to slow it down by (or prevent a reaction) raising the activation energy (hill).

The Two Fundamental Drives in Nature

1) Enthalpy (∆H): Tendency in nature toward a lower energy state. Nature favors loss of heat (lower enthalpy) Exothermic reactions are favored The activation energy for exothermic

reactions less than endothermic reactions. This makes it more likely for exothermic reactions to have enough activation energy to be successful.

The Two Fundamental Drives in Nature

2) Entropy (∆S): The tendency of nature toward a state of randomness, disorder, chaos.

Tidy room, Low Entropy Messy room, High Entropy

Entropy The greater the disorder, the higher

the entropy. Nature favors higher entropy. As temperature increases, entropy

increases Low entropy = more order High entropy = more chaos, disorder,

randomness.

The Two Fundamental Drives in Nature

1. Toward lower enthalpy (heat) (-∆H)2. Toward greater entropy (randomness)

(+∆S)

A spontaneous reaction occurs if the 2 drives are met. If the 2 drives are not met, the reaction does NOT occur.

Thermochemical EquationsEnergy is stored in chemical bonds!

Heat of Reaction: ∆H = Hp – Hr(change of energy – heat of a chemical reaction)

Matter always tries to reach lower potential energy.Nature favors exothermic reactions.Low enthalpy (low energy) = increased stability.

Thermochemical Equation: an equation that indicates the energy change (∆H). The phases of all substances will be shown.

Types of Reactions1. Endothermic: heat is absorbed.

Heat is shown as a reactant. Heat of the reactants is lower than the heat of the

products. ∆H is positive. Enthalpy is high in these reactions. These reactions are NOT favored in nature.

Ex) 2H20(l) + 571.6kJ 2H2(g) + O2(g)

Question: If 4 moles of H2O(l) decompose, how much heat is absorbed?

Types of Reactions2. Exothermic: heat is released.

Heat is shown as a product. Heat of the reactants is higher than the heat of

the products. ∆H is negative. Enthalpy is low in these reactions. These reactions are USUALLY favored in nature.

Ex) 2H2(g) + O2(g) 2H20(l) + 571.6kJ

Question: If 1 mole of H2O(l) forms, how much heat is absorbed?

Using Table ITable I: shows the ∆H for some common chemical

reactions at 101.3 kPa and298K.

The table depends on the # of moles (coefficients).∆H is measured in kiloJoules, kJ

The most endothermic reaction has the highest positive charge.

The most exothermic reaction has the lowest negative charge.

Some of the reactions are combustion, some are synthesis, and some are decomposition.

Questions:1) What is the ∆H for the formation of 2 moles of H20(l)?

2) What is the ∆H for the formation of 2 moles of H20(l)?

3) Which of the above 2 is more stable? Why?

4) Is the formation of 2 moles of NO(g) or NO2(g) more stable?

5) How much heat is absorbed or released by the domposition on 1 mole of NH4Cl(s)?

6) How much heat is absorbed or released by the formation of 3 moles of NH4NO3(s)?

7) What is the ∆H for the decomposition of 1 mole of C2H4(g)?