an naafi exports brochure
TRANSCRIPT
1 | P a g e
An-Naafi Exports
MANUFACTURERS OF REINFORCEMENT RODS OR DEFORMED
RODS OR COLD DRAWN STEEL WIRES OR NON ALLOY STEEL
BARS
REGISTERED OFFICE:TRANSIT CAMP,39/305,NEAR RIZVI
GARDEN ,BANDRA RECLAMATION,BANDRA WEST,MUMBAI
400 050,INDIA.
FACTORY ADDRESS:PLOT NO.608, ROAD NO.5, K.W.C.
KALAMBOLI, TAL. PANVEL. DIST. RAIGAD PIN 410208,INDIA.
PARTNERS:RAAFID KHALID SHAIKH
HUMED MEBOOBALI QURESHI
CONTACT DETAILS:00-91-9867862377/00-91-9769796794/
022-26555732
Skype id-annaafiexports
2 | P a g e
Introduction AN-NAAFI EXPORTS brings certain strength, from high-rise, to highway,to high-country with quality steel products. We are INDIA’s only manufacturer of reinforcing bar and coil products, wire rod, and galvanised wire. Our products are designed to be resilient in the toughest local conditions from the sharp shock of earthquake to the slow corrosion of salt-laden air.
Coil - One continuous piece of wire as drawn in the form of a coil.
Wire -. Cold-drawn steel wire of circular cross section.
3 | P a g e
OVERVEIW OF An-Naafi
Exports
Production of 200 Tones Monthly Situated near the Port (20kms) (NHAVA SHEVA/JNPT) Raw Material procurement within 1/2kms
circumference. Stuffing Done within the Factory and directly headed
towards the PORT. Wide Factory Area with 9000sqmtrs. Pioneers in India who are making this size of 3.4mm Registered with ALL INDIA EXPORTERS
CHAMBERS,FIEO,SMALL SCALE INDUSTRY BY STATE GOVERNMENT (SSI CERTIFICATE)
4 | P a g e
5.5mm
3.5mm
Cold -drawn wire shall be supplied in the following nominal
sizes:
Diameters of Cold-drawn wire 3.5, 4.0, 4.5,4.75, 5.0, 5.3, 5.5.
The tolerance on the nominal diameter shall be +- :1or2 percent.
MANUFACTURE AND CHEMICAL COMPOSITION
Chemical Analysis Element C Mn Si S P
Min% 0.06 0.45 0.10 - -
Max% 0.10 0.60 0.22 0.045 0.045
All figures are weight percentage values
Physical Properties Nominal Diameter (mm)
Diameter (mm)
0.2% Proof Stress (MPa)
Tensile Strength (MPa)
Max. Mandrel Diameter (mm)
3.55 3.52-3.58 Min 485 575-775 3.5
4.00 3.94-4.00 Min 485 575-775 4.0
5.00 4.97-5.03 Min 485 575-775 5.0
5.5 5.54-5.66 Min 485 575-775 5.5
5 | P a g e
USE OF THE PRODUCTS
1. Beams, Girders, Foundation walls, or Floors 2. Contraction joints in Roads and Runways, and
for Column spirals. 3. Surrounding concrete and Prevent Slippage. 4. Deform mesh 5. Most cost-effective option for construction and
repair of roads, bridges, and large industrial
plants.
6. Protect the land from erosion, used for fence
and frame construction.
6 | P a g e
Today, it is impossible that a modern building is without reinforcement Mesh
or Bar or Rods
AN-NAAFI EXPORTS