application note 100 - cimarron technologies corp cim-1200 installation notes for the kenwood...
TRANSCRIPT
AN: 100 Date: April 6, 2011 Page 1 of 3
Model Number: CIM-1200 ANI Encoder
Description: CIM-1200 Installation Notes for the Kenwood TK-690/790/890
(For Conventional Use Only)
Application Note
PROCEDURE: 1. Prepare CIM-1200
• Install Jumpers V and E. (See Page 2)
2. Program the CIM-1200 • Use the QuikWare Programming Software to make the following changes:
• Set TX Level 40
• Set Key Follows PTT to ‘YES’
• If Sidetone is desired, set PTT Side tone Audio Level to 50
• Set ID, Signaling Format, etc.
• If Emergency function is not desired, do not program IN1 for Emergency
3. Program the radio with KPG-44D as follows: • Go to ‘Model Information’> ‘Option Board’ select ‘ANI Board’.
• Go to ‘Edit’> ‘Optional Features’> ‘Optional Features 2’> ‘PTT ID’>‘ID Format’ select ‘ANI Board’.
• Go to ‘Channel Edit’ check the ‘PTT ID’ box for each channel that you want ANI on.
• If Emergency function is not desired, do not program a key for Emergency
• Go to ‘Edit’> ‘Key Assignment’ and choose the button desired for ‘Emergency Call’.
• Go to ‘Edit’> ‘Emergency Information’ select the Group/ Channel desired for Emergency, and under ‘Emergency Type’ select ‘ANI Board’.
Input / output Function Signal
IN0 PTT Low IN1 EMERGENCY Low OUT0 Key Output High OUT1 Critical Revert High
OUT2 Mic Mute High All Pull-ups = OFF, All debounce = 10mS
AN: 100 Date: March 31, 2011 Page 2 of 3
Model Number: CIM-1200 ANI Encoder
Description: CIM-1200 Installation Notes for the Kenwood TK-690/790/890
(For Conventional Use Only)
Application Note
Function Connector CIM-1200
PTT CN508 12 PAD 2 A+ CN508 13 PAD 12 A- CN508 14 PAD 13
DATA CN507 10 PAD 11 TONE CN507 8 PAD 14
Mic Mute CN507 7 PAD 6 Critical Chan CN507 4 PAD 3
KEY CN507 3 PAD 1 EMERGENCY CN507 2 PAD 4
From Step 1:
Jumpers V E
PROCEDURE: 4. Connecting the CIM-1200 to the Kenwood connectors
• Two connectors are required for this install. These connectors are Kenwood part numbers: E37-0809-05 & E37-0808-05.
• Strip 1/16” & tin • Cut unused wires flush with the connector
Note: Kenwood wire colors can vary !
1.5 in
2.0 in