autodesk inventor engineer s handbook · 2017. 11. 28. · autodesk inventor engineer s handbook...
TRANSCRIPT
1
AUTODESK INVENTORانجمن اینونتور ایران/ هندبوک مهندسی نرم افزار
Autodesk Inventor Engineer s Handbook
انجمن اینونتور ایران
www.irinventor.com
Tel: 09352191813 &
021-46088862
قابل توجه خوانندگان عزیر: کلیه مطالب [
Autodeskاین هندبوک از سایت شرکت
]کپی برداری شده است.
Autodesk Inventor هندبوک مهندسی نرم افزار
Engineer s Handbook
Plate
Calculator
2
AUTODESK INVENTORانجمن اینونتور ایران/ هندبوک مهندسی نرم افزار
Circular flat plates
Cross section size
A = π R 2
Edge supported around the circumference, load distributed uniformly over the surface
Maximum stress
Deflection
Rotation at support position
Edge fixed around circumference, load distributed uniformly over the surface
Maximum stress
Deflection
Edge supported around the circumference, load concentrated at the center
Maximum stress
3
AUTODESK INVENTORانجمن اینونتور ایران/ هندبوک مهندسی نرم افزار
Deflection
Rotation at support position
Edge fixed around circumference, load concentrated at the center
Maximum stress
Deflection
Strength check
σ max ≤ S y / k s
k s ≤ k
4
AUTODESK INVENTORانجمن اینونتور ایران/ هندبوک مهندسی نرم افزار
Square flat plates
Cross section size
A = L 2
Square flat plate supported at all four edges and a load distributed uniformly over the surface of
the plate.
Max. stress
Deflection
Square flat plate with all edges firmly fixed and a load distributed uniformly over the surface of
the plate.
Max. stress
Deflection
Square flat plate with all edges firmly fixed and a uniform load over small circular area at the
center.
Max. stress
5
AUTODESK INVENTORانجمن اینونتور ایران/ هندبوک مهندسی نرم افزار
where:
r 0 = radius of area to which load is applied. If r 0 < 1.7t, use r s where r s = √(1.6r 0 2 + t 2 ) - 0.675t.
Deflection
Square flat plate with all edges supported above and below, or below only, and a concentrated
load at the center.
Max. stress
Deflection
Strength check
σ max ≤ S y / k s
k s ≤ k
6
AUTODESK INVENTORانجمن اینونتور ایران/ هندبوک مهندسی نرم افزار
Rectangular flat plates
Cross section size
A = L 1
Rectangular plate with all edges supported at top and bottom and a load distributed uniformly
over the surface of the plate.
Max. stress
Deflection
Rectangular plate with all edges fixed and a load distributed uniformly over the surface of the
plate.
Max. stress
Deflection
Strength check
7
AUTODESK INVENTORانجمن اینونتور ایران/ هندبوک مهندسی نرم افزار
σ max ≤ S y / k s
k s ≤ k
------------------------------------------------------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------------------------------------------------------
Web: www.irinventor.ir Email: [email protected] & [email protected] Tel: 09352191813 & 021-46088862