bu irma

8
Teknik Telekomunikasi Kelompok 2 Nama Anggota : 1. Agustina Aryanti (061130330957) 2. Herdani Agustina(061130330969) 3. Iga Cornellia (061130330968) 4. Indri Anastasya (061130330967) 5. Maya Sari R (061130330971) Kelas : 3 ETA SECTION 1 GENERAL INFORMATION 1.1. System Description This manual contains information required to perform experiments associated with an amplitude modulated transmitter using ED Engineering TU-3400 Am transmitter. A similar system on the receiver, RU-3400 AM receiver, is also available from ED Engineering. A user can build a complete transceiver by purchasing both TU-3400 and RU- 3400, and coupling them together (See 1-2b).

Upload: agustina-aryanti

Post on 28-Oct-2015

40 views

Category:

Documents


9 download

DESCRIPTION

bu irma

TRANSCRIPT

Page 1: bu irma

Teknik Telekomunikasi

Kelompok 2

Nama Anggota : 1. Agustina Aryanti (061130330957)

2. Herdani Agustina(061130330969)

3. Iga Cornellia (061130330968)

4. Indri Anastasya (061130330967)

5. Maya Sari R (061130330971)

Kelas : 3 ETA

SECTION 1

GENERAL INFORMATION

1.1. System Description

This manual contains information required to perform experiments associated with an

amplitude modulated transmitter using ED Engineering TU-3400 Am transmitter. A

similar system on the receiver, RU-3400 AM receiver, is also available from ED

Engineering. A user can build a complete transceiver by purchasing both TU-3400 and

RU-3400, and coupling them together (See 1-2b).

The transmitter set TU-3400 is a modular. High frequency band radio transitter system

designed to provide the user with basic background knowledge and step by step

experiment instructions.the user will gain experience on AM transmission in a short

period of time and relatively easy way.

Each module in the system, which represents different function in the AM transmitter,

is designed with user friendly features such as a printed printed block diagram on the

panel and conviniently located input/out-out terminals, control knobs, indicators and

test points.

Page 2: bu irma

The output frequency of the transmitter is either cotinuously variable or discrete by

selecting one of the four crystal oscillator channels. The maximum output power of the

transmitter is 5 watts over a frequency range of 3.5 MHz to 12 MHz.

Detailed, full page figures on each module are attached at the end of this manual.

The TU-3400 is consisted of the following modules:

- TU-3400A Carrier Oscillator

- TU-3400B Frequency doubler and buffer Amplifier

- TU-3400C RF Power Amplifier

- TU-3400D Pi (π)-Network tuning amplifier

- TU-3400E Modulation power amplifier

- TU-3400P Power Module

- Microphone

1.2. Considerations before use

To ensure safe and efficient operation, the user must understand and follow the

information contained in this section as well as in this manual.

a. DC Power – The TU-3400P power module provides 24V DC to the RF power

amplifier (TU-3400C) and the modulation power amplifieer (TU-3400E). The

power module also provides 12V DC to the remaining modules.

b. The TU-3400P power module provides another output which is a break-in control

signal. This signal is used to syncrhonize the transmitter and the receiver. This

means that when the transmitter is transmitting, the receiver is disabled until the

transmission is over. Similary, when the receiver is on, the transmitter will not be

able to ransmit.

c. Shielded RF cable should be used in connecting between modules. Minimize the

length of the connecting cables.

Page 3: bu irma

d. A LOCAL-REMOTE operation is available from TU-3400. When the switch on the

module is selected to REMOTE, the transmitter/receiver as a system is normally in

receiving mode all the time except when the PTT (Push To Talk) switch on the

microphone is pressed.

e. When using the transmitter, make sure you have a liscense to transmit RF signal.

Use a dummy load at the antenna terminal to prvent accidental, unwanted

transmission. Always pay attention to any radio frequency interference (RFI) to

others due to improper operation.

f. Try to limit the on-time of theRF power amplifier to nomore than 3 minutes. This

will prevent overheating the power amplifier stage. Also it will minimize the

chance of generating RFI to others.

Page 4: bu irma

BAGIAN 1

INFORMASI UMUM

1.1. Penjelasan Sistem

Buku pedoman ini berisi informasi yang dibutuhkan untuk melakukan percobaan yang

berhubungan dengan sebuah pengirim modulasi amplitido yang menggunakan mesin

pengirim ED TU-3400 AM. Sistem yang sama terdapat pada penerima, RU-3400 AM,

yang juga tersedia dari mesin ED. Pengguna dapat membuat seperangkat alat pengirim

dan penerima yang lengkap dengan menggunakan keduanya TU-3400 dan RU-3400,

dan memasang keduanya bersama (lihat 1-26).

Seperangkat pengirim TU-3400 adalah sebuah pemodulasi. Sistem pengirim sinyal

frekuensi tinggi dirancang untuk membimbing pengguna tentang pengetahuan dasar

dan petunjuk langkah-langkah percobaan. Pengguna akan mendapatkan pengalaman

tentang transmisi AM dalam waktu yang singkat dan dengan cara yang cukup mudah.

Masing-masing petunjuk di setiap sistem yang ditampilkan dengan fungsi yang berbeda

pada AM transmitter, dirancang dengan komponen yang mudah di mengerti pengguna

seperti cetakan diagram blok pada papan dan mudahnya menetapkan pusat

masukan/keluaran, tombol-tombol pengatur, indikator dan titik uji.

Frekuensi keluaran dari pengirim keduanya merupakan nilai yang berlanjut atau

berlainan dengan pemilihan satu dari empat chanel osilator kristal. Keluaran

maksimum daya pada pengirim adalah 5 watt melebihi sebuah frekuensi yang bernilai

3,5 MHz sampai 12 MHz.

Dijelaskan, bentuk panggilan penuh tertera pada akhir buku petunjuk ini.

TU-3400 dibentuk dari:

- TU-3400A Pembawa osilator

- TU-3400B frekuensi ganda dan penahan suara

- TU-3400C RF daya amplifier

- TU-3400D Pi(π) Penyetel jalur jaringan

- TU-3400E Modulasi power amplifier

Page 5: bu irma

- TU-3400P daya modul

- Pengeras suara

1.2 Hal-Hal yang harus diperhatikan sebelum penggunaan

Untuk memastikan keselamatan dan pelaksanaan yang efisien, pengguna harus

mengerti dan mengikuti informasi yang berhubungan pada bagian ini sebaik mungkin

menggunakannya.

a. Power DC – Power TU-3400P tersedia dari 24V hingga power RF amplifier (TU-

3400C) dan modulasi power (TU-3400E). Power modul juga tersedia 12 V untuk

sisa modul.

b. TU-3400P daya modul tersedia dalam keluaran lain yang merupakan pengatur

sinyal pemasuk. Sinyal tersebut digunakan untuk keseimbangan antara pengirim

dan penerima. Artinya bahwa ketika pengirim digunakan, penerima diputuskan

hingga pengiriman berakhir, begitu juga sebaliknya, penerima aktif, pengirim tidak

akan bisa mengirim.

c. Perlindungan kabel RF harus digunakan untuk menghubungkan antara komponen.

Memperkecil panjang kabel penghubung.

d. Operasi remote lokal tersedia dari TU-3400. Ketika alat dihidupkjan dengan dipilih

menggunakan remote, pengirim/penerima sebagai sistem normal menerima semua

cara setiap waktu kecuali tombol PTT pengeras suara ditekan.

e. Ketika pengirim digunakan, yakinkan bahwa anda mempunyai izin untuk mengirim

sinyal RF. Gunakan beban tiruan pada pusat antena untuk mencegah kesalahan

yang tidak diketahui pengirim. Selalu perhatikan banyaknya gangguan dari suatu

frekuensi radio (RFI) ke yang lainnya disebabkan oleh operasi yang salah.

f. Batas percobaan setiap waktu menghidupkan pengeras suara RF tidak lebih dari 3

menit. Ini akan mencegah panas yang berlebih pada pengeras suara. Itu juga akan

mengurangi pergantian pada sentral listrik yang lain.