dear avital, · web viewhydrospin survey thank you for your enquiry. in order for us to...

2
HydroSpin Survey Thank you for your enquiry. In order for us to estimate the amount of power the HydroSpin unit would produce for your site, and to understand your needs better, please provide the following information: Name: ……………………………………………………………………… Address: ……………………………………………………………………………... Phone: ……………………………………………………………………… Email: ......................................................................... ............. 1. Operating Voltage: Please indicate the VDC required from our HydroCharger (electronic box): 12 VDC / 24 VDC. 2. Pipe Diameter: The generator is fitted to 3'' (80MM) / 4'' (100MM) / 6'' (150MM) / 8'' (200MM) diameter pipeline. Please indicate the pipe diameter where the generator will be installed: …………………………………… What is the existing specifications in the point intended for installation (Description of the place)? Above \ below ground In a chamber \ pipe facility\ Kiosk Water pool exit \ Reservoir \ Neighborhoods entrance \ Somewhere on the water network Other: …………………………………………………… 3. Flow Rate: HydroSpin Monitoring Solutions, Netanya, 8 Ha'zoran St., Israel Tel: +972-74-7136666 | Fax: +972-4-6709014 | Email: [email protected] | http://www.h-spin.com

Upload: trinhhuong

Post on 20-Mar-2018

214 views

Category:

Documents


2 download

TRANSCRIPT

Page 1: Dear Avital, · Web viewHydroSpin Survey Thank you for your enquiry. In order for us to estimate the amount of power the HydroSpin unit would produce for your site, and to understand

HydroSpin Survey Thank you for your enquiry. In order for us to estimate the amount of power the HydroSpin unit would produce for

your site, and to understand your needs better, please provide the following information:

Name: ……………………………………………………………………… Address: ……………………………………………………………………………...

Phone: ……………………………………………………………………… Email: ......................................................................................

1. Operating Voltage:

Please indicate the VDC required from our HydroCharger (electronic box):

12 VDC / 24 VDC.

2. Pipe Diameter:

The generator is fitted to 3'' (80MM) / 4'' (100MM) / 6'' (150MM) / 8'' (200MM) diameter pipeline. Please indicate the

pipe diameter where the generator will be installed: ……………………………………

What is the existing specifications in the point intended for installation (Description of the place)?

Above \ below ground

In a chamber \ pipe facility\ Kiosk

Water pool exit \ Reservoir \ Neighborhoods entrance \ Somewhere on the water network

Other: ……………………………………………………

3. Flow Rate:

Please indicate average expected flow rate: Min: ………. Max: ……… Avg: ……….

Average time without water flow: …………... Hours.

4. Cable Run:

The total distance from HydroCharger location to Generator unit (Cable 4 on illustration below). Our standard size –

3M. Cable Length: …………………. (Meters)

HydroSpin Monitoring Solutions, Netanya, 8 Ha'zoran St., Israel

Tel: +972-74-7136666 | Fax: +972-4-6709014 | Email: [email protected] | http://www.h-spin.com

Page 2: Dear Avital, · Web viewHydroSpin Survey Thank you for your enquiry. In order for us to estimate the amount of power the HydroSpin unit would produce for your site, and to understand

5. Energy consumption required on hourly basis (Watt)? Min: ………. Max: ……… Avg: ……….

Device type: (Data loggers, water quality sensors, PRV, remote water meters, pressure & flow measurement etc.):

……………………………………………………………………………………..

Note: If any of the above terminology is unclear, or if you are unsure of how to measure flow rate or any other

required parameter, please don’t hesitate to contact us for assistance.

HydroSpin Monitoring Solutions, Netanya, 8 Ha'zoran St., Israel

Tel: +972-74-7136666 | Fax: +972-4-6709014 | Email: [email protected] | http://www.h-spin.com