Download - CCNA Based routing protocols
CCNA BASED NETWORKING OF RIP AND OSPF WITH ACCESSLIST AND
FRAME RELAY IN ROUTERS
Supervised By Gaurav Singh RawatProf. S.C.Gupta Systems EngineeringElectrical Engineering 12316EN009
Introduction
Today computer network are the core of modern communication. All modern aspects of the public switched telephone network(PSTN) are computer controlled. These increasingly runs over the internet protocols.
In network layer we are using the routing of IP packets.
Cont..
S= time ofBursty M=outputTraffic rate
Capacity=C token rate=₱Bursty traffic is define as a sudden increase in traffic in steady
state traffic.Suppose capacity of router is 1mbps, output rate of data is 8
mbps. Token are generated is 6mbps. Calculate the time at which bursty traffic is routed.
C+ ₱S=MS;10^6+6*10^6*S=8*10^6*S
S=0.5 sec
Router
Problem Definition
Cisco has dominated the router industry for many reasons. One of the most common reasons is Cisco’s support for a multitude of protocols as well as features in their IOS to enhance a router’s ability to control traffic and improve performance, and in some cases, save money. To take the features and functionality that helped Cisco become the leader in terms of market share
There will be wasting of IP addresses is problem in Routing. So we are using Subnetting but Subnetting is also not that much sufficient so we use the Supernetting concept. In this report we are configure the routing protocols and there behavior. And compare those routing protocols. And also work basic level in access-list and Frame-relay with respect to RIP and OSPF.
Cont..
Two Tier Routing Internet System Inter-domain routing:
• Routing policies based on business relationships
• Routing of packets done b/w autonomous system.
• BGP: policy-based, path-vector routing protocol
Intra-domain routing:• Shortest-path routing based on link metrics• Routers all managed by a single institution• OSPF and IS-IS: link-state routing protocol• RIP and EIGRP: distance-vector routing
protocol
RIP(Routing Information Protocol)
It’s a dynamic vector routing protocol. It’s a intra-domain routing protocol.
In this we use the Bellman Ford algorithm. Used as a hop count to calculate optimal
route. Rip uses Classfull routing, not subnetting. Slow convergence in large area. Count to infinity problem.
Rip Configuration
Cont…
Cont…
PDU(Protocol Data Unit)
Open Shortest Path First(OSPF)
OSPF is an interior gateway protocol(IGP) link state protocol.
All routers within an area have exact same link state database and run in parallel with the shortest path or Dijkstra algorithm.
OSPF is a classless protocol. OSPF uses cost as its metric, based on
bandwidth of the link OSPF has no hop count.
OSPF Configuration
Cont…
Cont…
Cont..
PDU(Packet Data Unit)
PDU(Packet Data Unit)
Difference between RIP and OSPF
Cont…
Access Control List Filter’s Traffic
Access Control List Working
Configure Access List on Router
Block Host to Host
Block Host to Network
Block Network To Network
Block Network to Host
Application of Extended Access List
Stop ping but access web server
Cont…
Frame Relay
A Frame Relay network may be privately owned, but it is more commonly provided as a service by a public carrier.
It typically consists of many geographically scattered Frame Relay switches interconnected by trunk lines.
Frame Relay is often used to interconnect LANs. When this is the case, a router on each LAN will be the DTE
DTE and DCE
DLCI: A data-link connection identifier (DLCI)
identifies the logical VC(virtual circuit) between the CPE(customer premise equipment) and the Frame Relay switch.
The Frame Relay switch maps the DLCIs between each pair of routers to create a PVC (Permanent Virtual Circuit).
LMI – Local Management Interface: LMI is a signaling standard between the
DTE and the Frame Relay switch. LMI is responsible for managing the
connection and maintaining the status between devices
Case Study
LMI Local Management Interface
Packet transfer from one state to other state
Conclusion and Future work When considering with RIP, OSPF handles
its own error detection and correction function
Now in future we widely work on access-list, and frame relay. And study all the protocols (MPLS, IS-IS, MPBGP) which are different routing algorithms.
The Cisco Visual Networking Index (VNI) Forecast (2012-2017), published today, projects that global Internet protocol (IP) traffic will grow three-fold between 2012 and 2017.
Global IP traffic (fixed and mobile) is expected to reach an annual run rate of 1.4 zettabytes ― more than a trillion gigabytes per year – by 2017. On a monthly basis, global IP traffic is expected to reach nearly 121 exabytes per month by 2017, up from about 44 exabytes per month in 2012. (121 exabytes is equivalent to 30 billion DVDs; or 28 trillion MP3's; or 750 quadrillion text messages.) This updated study includes global fixed IP traffic growth and service adoption trends, complementing the VNI Global Mobile Data Traffic.
Cont…
Reference
Visual Learning in Science and Engineering, ACM SIGGRAPH/Eurographics Workshop on Computer Graphics Education held June 2-5, 2004, in Hangzhou, China.
G. Laporte, I.H. Osman, A bibliogaphy of routing problems, 1.4 page 14 ISBN-81-203-0621-X
computer network Second edition Andrew S. Tanenbaum vrije universiteit amsterdam, the netherlands
Cont…
http://www.cisco.com/univercd/cc/td/doc/product/netsec/secmgmt/asdm/index.html
http://www.cisco.com/en/US/docs/security/asa/command-reference/p1.html.
https://www.netacad.com/web/about-us/cisco-packet-tracer.
THANK YOU