-
Saneren met ijzer injectieDirecte injectie
Martin Ohse, Groundwater TechnologyWouter Vandeputte, Enissa – MAVAPaola Goria, FMC Adventus
-
Onhafankelijk aannemer gespecialiseerd inin-situ sanering
• ISCO, ISCR, ISSTAB via direct- push, filters• Stoom-injectie• Alle andere in-situ technieken (MFE, VER, Bio, ….)
Vestiging in Brussel (GT BVBA) Rotterdam (GT BV)
www.gtbelgium.be
Groundwater Technology
-
Introductie
Directe injectie van micro-ijzer en substraat:een combinatie van anaerobe
en abiotisch afbraak
Van Bodemonderzoek naar succesvol ‘case closed’• Waar zit de verontreiniging?• Bodemopbouw?• Direct injectie van ijzer en substraat• Tussentijdse evaluatie (VOCl, DOC, Fe2+)
ISCR, EnISSA
EHC van Adventus
Tweede injectie ronde …..
-
In Situ Chemical Reduction: success?
Main issue: Where to inject?
ISCRmet micro ijzer injectie
-
Traditional approachInterpreted contour
Sampling wellInjection wells
ISCRmet micro ijzer injectie
-
Detect
Interpret
Inject
Effect
Remediation design:
Is function of soil stratigraphy, hydraulicproperties, distribution of VOC’s, …
Input from:
EnISSA MIP
Conv. MIP
CPT
HPT (hydraulic profiling tool)
…
Improved conceptual site model
ISCRmet micro ijzer injectie
-
111-TCA
11-DCA
TCE
11-DCE
distance (cm)
depth (cm)
conc (ug/l)
Ex. EnISSA Logs:
Component specific detection
Leads to accurate 3D image ofcontaminant distribution
-
Dynamic approachInterpreted contour
EnISSA, MIP, …
Direct push injection
Direct push injection
ISCRmet micro ijzer injectie
-
Benefits:• Using EnISSA: * improved image of start condition before remediation
* injection volume based on contamination (conc level & component)
• Reduced consumption of product
• Less use of raw materials
• lower overall soil impact (redox changes)
• Minimize required mobilizations (sampling …)
• Optimized effect of product injected
ISCRmet micro ijzer injectie
-
ISCRmet micro ijzer injectie
Anaërobe afbraak van VOCl’s•Redox naar -150/-250 mV door injectie van substraat•Afbraakpad: PER � TRI � CIS �VC � Ethaan en Etheen (Risicovan stagnatie en verspreiding van CIS en VC)
Chemische Reductie• Injectie met Nulwaardige ijzer verlaagt het redoxpotentiaal tot -300/-
500 eV
• De VOCl’s worden chemisch onstabiel bij extreem lage Redox:
Fe0 � Fe2+ + 2 e-
R-Cl + H+ + 2 e- � R-H + Cl-
Fe0 + R-Cl + H+ � Fe2+ + R-H + Cl-
Combinatie met andere techniekenSubstraat injectie, ISSTAB, Puurproduct verwijdering, ...
-
EHC van Adventus - Injectable controlledrelease solid carbon, nutrients & ZVI
• Organisch substraat• Micro ijzer deeltjes (ZVI)• Nutrienten• pH buffer
ISCRmet micro ijzer injectie
EHC� Direct injectie
EHC-A� Via filters
-
Bodemopbouw :• 0 – 2 m-mv: zand
• 2 – 6 m-mv: klei• 6 – 7 m-mv: klei en veen
• > 7 m-mv: fijn zand
Case study - Weesp
Verontreinigd met VOCl
• Vooral TRI, CIS, VC
• Som VOCl = 40.000 µg/l• 150 m² - 750 m³
EHC• Direct push injectie
• 35 injectie punten tot 7 m-mv� Slurry met 1500 kg EHC
-
Case study - Weesp
-
Case study - Weesp
-
Uit ervaring:• Top down of bottom-up• In twee ronde om geen saturatie te krijgen
• Tijdelijk vorming van afbraak product is mogelijk
• Laag redox (onder -200 mV) is moeilijk meetbaar op het veld• Kan tijd nemen om daling te meten (tot 1,5 jaar) � Vooral met klei
Case study - Weesp
18 maanden na injectie• Enkel nog VC boven BSN
• IJzer (Fe2+) nog aanwezig (200 mg/l)• Substraat nog aanwezig (DOC 2.000 mg/l)
• Redox potentieel blijft laag (ca. – 200 mV)
-
Meer info, factsheets:
Groundwater Technology BVBAFernand Bernier straat, 15
1060 Brussel
Contact: Martin OhseEmail: [email protected]
Tel: +32(0)2 543.44.49
www.gtbelgium.be
Bedankt!
EnISSA / MAVAGorislaan 49
1820 Steenokkerzeel
Contact: [email protected]
FMC's Adventus Environmental SolutionsContact: Mike Mueller
Tel: +43 5238.53262Mobile +43 664.180.3060