fm26(a4)
TRANSCRIPT
-
8/2/2019 FM26(A4)
1/3
SOLTEQ
FLOW OVER WEIRSMODEL: FM 26
THISFlow Over Weirs (Model: FM 26) apparatus comes with two weir plates of different shapes, thus
allowing familiarisation and comparison with theory. The unit consists of the following used in conjunction
with the flow channel in the moulded bench top of a Hydraulics Bench:
a) A quick release connector in the base of thechannel is unscrewed and a delivery nozzle
screwed in its place.
b) A stilling baffle locates into slots in the walls of the
channel. The inlet nozzle and stilling baffle in
combination promote smooth flow conditions in
the channel.
c) A Vernier hook and point gauge is mounted on aninstrument carrier which is located on the side
channels of the moulded top. The carrier may be
moved along the channels to the required
measurement position.
d) The rectangular notch weir or vee (V) notch weir
to be tested is clamped to the weir carrier in the
channel by thumb nuts. The weir plates incorporate
captive studs to aid assembly.
Equipment for Engineering Education & Research
-
8/2/2019 FM26(A4)
2/3
SO
LTE
QEXPERIMENTAL CAPABILITIES
Flow characteristics demonstration over a
rectangular notch and a vee (V) notch.
Determination of the discharge coefficients.
SPECIFICATIONS
Weir Plates:
Height : 160 mm
Width : 230 mm
Thickness : 4 mm
Rectangular Notch:
Height : 82 mm
Width : 30 mm
Angle of vee notch weir : 90 inclusive
Hook & point gauge : 0 to 150 mm, 0.1 mm
REQUIREMENTS
Hydraulics Bench ( FM 110 )
SOLTEQ Equipment for Engineering Education & Research
-
8/2/2019 FM26(A4)
3/3
Our range of teaching equipment can be complemented with our
SOLDAS and SOLCAL software.
SOFTWARE & E - LEARNING
SOLDAS- Supervisory Control & Data Acquisition
- Data Logging
- Signal Analysis
- Process Control
- Real-Time Display
- Tabulated Results- Graph of Experimental Results
SOLCAL - Computer Aided Learning
- Multimedia Features
- Interactive- Graphic Simulation
- Experiment Result Samples
- Full Experiment Manuals
SOLTEQ
Contact us for a catalog CD
SOLUTION ENGINEERING SDN. BHD.(Co. No. 174876-M)
Sales Office :
No.3, Jalan TPK 2/4, Taman Perindustrian Kinrara,47100 Puchong, Selangor Darul Ehsan, Malaysia.Tel. No. : +(603) 80758000Fax. No. : +(603) 80755784
R&D Office :
G-2A, Incubator 3, Technology Park Malaysia,Bukit Jalil, 57000 Kuala Lumpur, Malaysia.Tel. No. : +(603) 8996 0023
Email : [email protected] site : http//www.solution.com.my/
AGENT:
Equipment for Engineering Education & Research
BUATAN MALAYSIA
MSC- StatusCompany