guide for worksheet 2
TRANSCRIPT
Guide for Worksheet 2
This powerpoint will have step-by-step guide. Look carefully where are the icons
and what are the common steps.
Exercise 1
Basic Sketch downloaded
Click Extruded Boss/Base
Click any line of figure after clicking Extruded Boss/Base
Change value here!
Click OK here!
Completed exercise 1
Go to exercise 2 …………………………………………………………………
Exercise 2
Offset entities seen only in Sketching mode
Follow Step 4
Look at what did the solid lines changes to?
Fillet
Shell
Select surface to “shell”
Finally…