7/29/2019 ir6000-041

1/2

(1/2)

Canon Service Bulletin COPIER

Issued by Canon Europa N.V.

Location:iR5000 Series DC-Controller PCB Assembly (v23.01)

Subject:

Releasing the DC-Controller Software (Ver.23.01)

Reason: Since the ROM program has been upgraded, it is now offered as Ver.23.01

Model:

iR5000iR5000diR5000iiR5020iR5020NiR6000iR6000diR6000iiR6020i

Ref No.:

iR6000-041

(F1-T01-0K9-10109-01)

Date:

25-06-04

Ver.No. Description

Ver.23.01

1)Correction of the failure that after selecting the thick paper

mode (FSPD-S1 -> 2) using Service mode, duplex printing is

performed using the thick paper, but the paper is not supplied

and the pick-up roller keeps rotating for more than 10

minutes.

2)Correction of the failure that hole punch position of the

Finisher (FIN-X2/3) is adjusted using Service mode, but after

a while, the setting value is not reflected and returns to the

default value (However, backup data has the correct

adjustment value.)

3)Correspondence to Europe request for 46IPM device

Production: Giessen, Specification: Europe

Production mark: F14-43 X 6

7/29/2019 ir6000-041

2/2

iR6000-041

(2/2)

Details: changes Made When Upgrading DC-Controller v23.01

.

Version Configuration: There is no limitation for the operating gurantee of the DC-Controller v23.01.

No. Item Description

1-1

Correction of the failure that after selecting thethick paper mode (FSPD-S1 -> 2) using Service

mode, duplex printing is performed using the

thick paper, but the paper is not supplied and the

pick-up roller keeps rotating for more than 10

minutes.

Like single-sized and reverse printing, at the fixing unit, if there is arequest that a sequent page is set to the thick paper mode, the request

is to be on demand . When the temperature reaches to the setting

temperature, feeding paper starts.

1-2

Correction of the failure that hole punch

position of the Finisher (FIN-X2/3) is adjusted

using Service mode, but after a while, the

setting value is not reflected and returns to the

default value (However, backup data has the

correct adjustment value.)

When Finisher's power is turned OFF, but the device's CPU is

running, in order to send the setting value to the Finisher when the

device is recovered from the low power mode, the data already sent to

the Finisher is recognized as unsent data so that the setting value is

resent to the Finisher.

1-3

Correspondence to Europe request for 46IPM

device

Production: Giessen, Specification: Europe

Production mark: F14-43 X 6

- "46IPM device" is to be added to the device code from the controller.

- 46IPM device is to control IPM of A4/LTR/B5 with 46IPM. (The

other paper size is the same as the one for 51IPM device.)

- However, IPM from stack bypass is to be the same as the one for

"51IPM device".

- Down sequence is to be the same as the one for "51IPM device".

Normal -> Down1 -> Down2

51IPM -> 40IPM -> 35IPM

46IPM -> 40IPM -> 35IPM

- Fixing temperature including energy saving and low power is to be

the same as the one for "51IPM device".