nota hangat kecut

Upload: chippychip

Post on 07-Aug-2018

240 views

Category:

Documents


0 download

TRANSCRIPT

  • 8/20/2019 Nota Hangat Kecut

    1/2

    Laporan cable gland

    Additionally, if operating a heat gun inside, make sure your area iswell ventilated, even if you're wearing a mask. Make sure your

    work area is free from any debris that may prove flammable, and

    for Pete's sake don't point the heat gun at yourself. That may seemlike common sense, but it's easier to do than you might think.

     Now, with that out of the way, let's see what this heat shrink stuff is

    all about.

    Step 1

    ike some kind of backwards !eorge "ostan#a, shrinkage occurs in this tubing when heat isapplied $hence the name %heat shrink&. (ut how much does it shrink, e)actly* +)cellent

    uestion. -electing the proper si#e of heat shrink tubing for your 

     proect is important. Two terms that are important to remember hereare recovered diameter $the diameter after shrinking and e)panded

    diameter $the pre/shrinkage diameter. 0n order to get a secure fit, be

    sure that the tubing's recovered diameter is smaller than thediameter of the area you're going to insulate. That way, when it

    shrinks you'll get a tight fit. At the same time, the tubing's e)panded

    diameter needs to be large enough to easily fit over the area to be

    insulated, as well as any connectors attached to it. "ommon sensewould dictate that if you can't comfortably fit your bundle or cables

    within a tube in the first place, shrinking it won't do you much good.

    Step 2

    1nce you've determined you have the proper dimensions for yourheat shrink, the ne)t step is to cut the heat shrink tubing to a

    usable length, and be sure to allow for a minimum 2345 overlap

    over any e)isting insulation or connectors. 6eep in mind thattubing also shrinks lengthwise7typically 8/9: during the

    shrinking process. Most heat shrink can be cut easily with

    standard scissors, though again if you're -maug or some otherdragon, you may wish

    to use your sword/liketeeth or spear/like claws, foregoing both the heat gunand the scissors.

    Step 3

     Now you've got everything all measured and cut, so

    it's time to slide the cut tubing over the obect, or 

  • 8/20/2019 Nota Hangat Kecut

    2/2

    obects, or small animal $; -ilicone lubricant spray can be applied to wires or cords to guide heat shrink over them

    without compromising the heat shri