PD3D

~

/(PD 50-//2-

tf-

X:!i?.

~3OPIID~~L-

"" SHOP-/III<.

II..> L~ r

/

//

j!

~J'/- &.$"T /(&SVLIS /,..;

3<-f;.;t:;;blt.J4 L IJJt;-~ Op6;tz..ArE

Dl,)M P IN TH t t POS ITION

~TII. ~ LooPS /AJ LINt) j-;;Rc q"ZJn£r-

~I::E

\It'..sE:-

Instructions:

After the unit is assembled and hooked up to hydraulic vise, fill oil cup. Place thepart in the vise against the stationary jaw. Hand crank the movable jaw between 1/8 to 1/4of a inch from part. The next step is to get the air out of the hydraulic line. Move hydrauliclever back and forth. Wait a few seconds and do it again you will see air bubbles showingup in oil cup and oil in cup disappear. Fill oil cup and repeat process until there are no airbubbles showing up in the oil cup. !fair is still in the hydraulic line under pressure (crack)loose the fitting down by the vise and then tighten.

REfERENCE -:.. -

/-

t"">(J,iAlJ:>i~~

APi) bo -IlL

.t)<H~()S"r

SUGGEST USING FILTER, REGULATOR & LUBRICAWR ..

FOR CLEAN SHOP AIR.