yasir labs designing

26
Muhammad Yasir Reg No= 2014-Mphil-2096. Topic , Requirements of clinical labs (Microbiology, Parasitology, Pathology)

Upload: uvas123123

Post on 15-Apr-2017

148 views

Category:

Documents


3 download

TRANSCRIPT

Page 1: yasir labs designing

Muhammad Yasir

Reg No= 2014-Mphil-2096.

Topic ,

Requirements of clinical labs (Microbiology, Parasitology, Pathology)

Page 2: yasir labs designing

BuildingA- Architectural Considerations Lab Planning Module A well-designed modular plan will provide the following benefits: Flexibility Expansion A common laboratory module has a width of approximately 10 ft. 6

in. but will vary in depth from 20-30 ft. The 10 ft. 6 in. dimension is based on two rows of casework and equipment on each wall, a 5 ft. aisle, and 6 in. for the wall thickness that separates one lab from another. The 5 ft. aisle width should be considered a minimum because of the requirements of the Americans with Disabilities Act (ADA).

Page 3: yasir labs designing

Conti… Flexibility In today's lab, the ability to expand, reconfigure, and permit

multiple uses has become a key concern. The following should be considered to achieve this: Flexible Lab Interiors Equipment zones Generic labs Mobile casework—This can be comprised of mobile tables

and mobile base cabinets. It allows researchers to configure and fit out the lab based on their needs as opposed to adjusting to pre-determined fixed casework.

Page 4: yasir labs designing

Conti… Flexible partitions—These can be taken down and

put back up in another location Flexible Engineering Systems Labs should have easy connects/disconnects at

walls and ceilings to allow for fast and affordable hook up of equipment. 

Page 5: yasir labs designing

Conti…Building Systems Distribution Concepts Interstitial Space: An interstitial space is a separate floor located above

each lab floor. All services and utilities are located here where they drop down to service the lab below. This system has a high initial cost but it allows the building to accommodate change very easily without interrupting the labs.

Page 6: yasir labs designing

B- Engineering Considerations

Structural Systems

• Framing depth and effect on floor-to-floor height;

• Ability to coordinate framing with lab modules

• Potential for vertical or horizontal expansion; Vibration criteria and Cost.

Page 7: yasir labs designing

Different section of Diagnostic laboratory

Page 8: yasir labs designing

Laboratory Design Considerations.Walls/Doors/Security

The laboratory shall be completely separated from outside areas (i.e., must be bound by four walls).

Having enclosed laboratories will help contain spills, keep unauthorized personnel from entering areas where hazardous operations are performed.

The laboratory shall have means of securing specifically regulated materials.Having secured hazardous materials storage will keep unauthorized personnel from gaining access to them.

Page 9: yasir labs designing

SinksEach laboratory must contain a sink for hand washing.Laboratory sinks shall have lips that protect sink drains from spills.

Chemical/Waste StorageChemical storage shelves shall not be placed above laboratory sinks.

Sufficient space or facilities shall beprovided so that incompatible chemicals/gases can be physically separated and stored.

WindowsIf the laboratory has windows that open, they must be fitted with insect screens.

Page 10: yasir labs designing

Furniture Design, Location, and Exit Paths

All furniture must be sturdy. All work surfaces (e.g., bench tops and counters) must be impervious to the chemicals used

EXIT

Clear aisles and exits are necessary to facilitate departure in the event of an emergency. The laboratory doors shall be automatically self-closing.

Illumination. Laboratory areas shall be provided adequate natural or artificial illumination toensure sufficient visibility for operational safety.

Page 11: yasir labs designing

Clean ability.

The laboratory shall be designed so that it can be easily cleaned. Bench tops must .

Break rooms

The design of the laboratory building must incorporate adequate additional facilitiesfor food storage/consumption and personal hygiene tasks.

The lab may have several pieces of equipment, which require large amounts of electrical current. Such items include freezers, biosafety cabinets, centrifuges, and incubators.

Electrical

Plumbing Auxiliary valves for gas and vacuum lines should be located outside the lab.

Page 12: yasir labs designing

•Biosecurity area.•Reception for collecting samples for test.•Waiting Areas•Postmortem area•Bacteriology section•Hematology section•Elisa test section•PCR section

Different portions of Diagnostic laboratory

Biosecurity section

Safety gownsGlovesGum shoesFoot dipsMaskAir filtersHead masks

Page 13: yasir labs designing

Reception of laboratory •Internal use .•Communicable receptionist. •The laboratory reception is clearly marked with the appropriate signage.

Customer waiting room•Sitting chairs.•Refreshment.•T.V or news paper .

Laboratory office work section Record keepingResearch purposeAddresses and contactsFor result.

Page 14: yasir labs designing

.

Instruments used in different labs

Page 15: yasir labs designing

Instruments usedin microbiology

Instrument sterilizers Used to sterilize instruments in absence of an autoclave

Dressing drums storage of gowns, cotton, linen, etc. The microscope used for visualizing minute structures including microbes. Various stains used to stain microscopic slides to get contrast Hot air oven used in sterilizing instruments for various aseptic procedures,

specially if that can not be autoclaved like powders. Koch's steam sterilizer used for steam sterilization A pressure cooker used as a portable autoclave. Biological and chemical indicators Used to ascertain if a certain process

has been completed, e.g. spores used in an autoclave are killed if autoclaving is properly done.

Filters: Candle filter: used as household water filters and as filters for large

particles in the laboratories.

Page 16: yasir labs designing

Conti… Disk filter  previously used as bacteriological filters; presently

obsolete Sintered glass filter used as a good particle filter in laboratories. Membrane filter and Syringe filter used as primary bacterial/cell

filters in procedure as toxin, immunoglobulin, etc. production, where the product gets denatured on heating.

Air filterlike HEPA filter, used in various laboratories and clean rooms to

produce lamellar air flow. Radiation: Gamma ray source used in sterilization of heat-labile products

like plastic or rubber syringes, catheters and gloves. X-ray source

Page 17: yasir labs designing

Conti… •Infrared light source •Ultraviolet light source Inspissator used to produce culture media for bacteriology that

contain egg or serum, which coagulate on heating. Tyndallizer a process of sterilization from spore bearing bacteria

; vide link Water bath to heat things uniformly from all sides at a set

temperature up to the boiling point of water. Needle Destroyer Burns the needle electrically either cuts the

syringe manually or burns it electrically Sharps container A imperforable container for sharp wastes like

needles, blades, microscope slides, broken glass, etc. Cardboard biomedical waste containers Reusable tubs

Page 18: yasir labs designing

Conti… Colour coded biomedical waste bags (India)  Yellow plastic bags for human anatomical, animal,

microbiological and soiled waste. Red disinfected container or plastic bags microbiological waste,

solid waste(IV tubes, catheters, etc.) Blue or White plastic bag or puncture proof containerssharps, disposable tubing, etc. Black Plastic bag or puncture proof containers discarded

medicines, incineration ash, chemical waste Disinfectants for cleaning Incinerators to burn biomedical wastes like removed body parts,

blood, gauze, linen, etc.

Page 19: yasir labs designing

This section is specified for biopsy, postmortem and tissue processing. Disinfection of the surfaces and proper disposing off of the waste is essential

Pathology section

Page 20: yasir labs designing

•Incubator•Haemacytometers with red and white pipettes•Haemoglobinometers, Sahili’type•Sedimentation apparatus-one wester green and one wintrobole•Syringes disposable one set from 10 cc to 2cc 30 of each.•Staining jars for slides.•Urinometers•Urine Glasset (Conical)•Centrifuge tubes graduated•Crucible with china ltd.•Crucible Gooch with adapter•Graduated cylinders for various capacities ranging from 100 cc to 1000 cc. .•Pipettes of various sizes, graduated sets•Reagent bottles.

CLINICAL PATHOLOGY LABORATORY REQUIRMENTS

Page 21: yasir labs designing

List of Equipment and Instruments•ctangular water bath•Centrifuge machine electric Rotofix•Colorimeter Photoelectric Klett.•Cabinet for 1000 slides•Band saw•Autopsy tables•Automatic tissue processor,•Histokinmettee or similar, complete•Staining racks for staining in bulk•Troughs for staining in bulk•Coplin jars•Water bath electric (Tissue Floatation•Balance, Chemical with weights•Microscopes•condenser•Oil immersion•Polarising attachments for microscopes

•Dropping bottles•Reagents•Balances 1) Sensitive balanceChemical balance with weight boxes

•Magnifying lens•Blood pressure instrument•Hot plat electric•Laboratory Counter nine keys clay Adams•Automatic timer•Balance for weighing organs•Saws, wire for cutting bones

Page 22: yasir labs designing

ELISA section

Sensitive section more care is required. Commercial kits and serum, blood samples are processed.

PCR sectionThermo cycler, processing of DNA,RNA samples. Primers, enzymes, and other essential solutions are managed in this section.

Bacteriology section

Bacterial culture, staining, biochemical tests, media preparation and management. Storage, incubation of samples. Sterilization, autoclaving procedure are present in this section

Page 23: yasir labs designing

Parasitology section

Specified section for parasites associated diagnosis. Fecal, blood skin etc are managed and processed

Page 24: yasir labs designing

EQUIPMENT IN THE PARASITOLOGY LABORATORY

•Refrigerator •Autoclave •Cleaning safety hoods •Stains•Reagents•Stereoscopic•Centrifuge machine •Fume Hood•Safety Cabin •Microscope•incubators•Weighing balance•Beakers•Refrigerator

.

. .

.• Haemoglobinometers, Sahili’type• Sedimentation apparatus-one wester

green and one wintrobole• Syringes disposable one set from 10 cc

to 2cc 30 of each.• Staining jars for slides.• Crucible Gooch with adapter• Graduated cylinders for various

capacities ranging from 100 cc to 1000 cc. .

• Pipettes of various sizes, graduated sets• Reagent bottles.

Page 25: yasir labs designing
Page 26: yasir labs designing

Thanks for your attention