三新電気香港有限公司 sanshin denki hk co., ltd technical information difference of...

三新電気香港有限公司三新電気香港有限公司

SANSHIN DENKI HK CO., LTDSANSHIN DENKI HK CO., LTD

Technical InformationTechnical Information

• Difference of production methodDifference of production method• Characteristic of our product Characteristic of our product • OthersOthers

XENON FLASH TUBEXENON FLASH TUBE

SPEC COMPARISONSPEC COMPARISON

CONTENTSCONTENTS Comp.WComp.W Comp.Comp.PP

S/KS/K

１１NOISENOISE GoodGood BetterBetter

２２ High Pressure High Pressure (PA)(PA)

About About 2.52.5

2.52.5

３３ Size (Ark length)Size (Ark length) 8mm8mm N/AN/A

CHEMBERCHEMBER 　　 METHODMETHOD

Company P,Company P,Company WCompany W

At the time of putting At the time of putting airair 　　

　　 pressure into xenon pressure into xenon tubes,tubes, 　　

about 30pcs of XE about 30pcs of XE tubes tubes

are put into a pot at are put into a pot at the the

same time. It is sealed same time. It is sealed byby

heater at the same heater at the same time. time.

CHEMBER METHODCHEMBER METHOD MERITS/DEMERITSMERITS/DEMERITS

MERITS :MERITS :＊＊ The outputs produced at the same time are The outputs produced at the same time are

largelarge

＊＊ xenon tube at required color temp is lowxenon tube at required color temp is low

DEMERITS :DEMERITS :＊＊ There is much dispersionThere is much dispersion

＊＊ Only 2.5 atmospheric pressure can not put Only 2.5 atmospheric pressure can not put inside the pot.inside the pot.

INDEX METHODINDEX METHOD （新光和）（新光和）• Produced one by Produced one by

oneone

• When xenon tube is When xenon tube is sealed, it is done by sealed, it is done by burner. And then burner. And then they are dipped into they are dipped into the Liquid Nitrogen the Liquid Nitrogen to cool it down at to cool it down at the momentthe moment. .

　　 Tungsten expands, Tungsten expands,

　　　　　　 glass shrinksglass shrinks..

　　　　　　　　　　　　↓↓＊＊ Slow leakage of GasSlow leakage of Gas

is hard to cause.is hard to cause.

＊＊ High Pressurization of High Pressurization of the enclosure gas is the enclosure gas is easily possible.easily possible.

THAT MEANS YOU THAT MEANS YOU CANCAN

GET MORE FLASHING GET MORE FLASHING LIGHT POWER!LIGHT POWER!

CHARACTERISTICCHARACTERISTICSS

• 1. Compression seal by the combination of the hard 1. Compression seal by the combination of the hard glass glass 　　

　　　　　　　　 and the tungsten electrode is adopted. and the tungsten electrode is adopted.

　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　• 　　　　 NO CHANGE OF THE SEAL(NO CHANGE OF THE SEAL( 経時変化無）経時変化無）• 　　　　 RESISTANT TO THERMAL SHOCK(RESISTANT TO THERMAL SHOCK( 熱衝撃強）熱衝撃強） • 2.The high-performance cathode sintering(2.The high-performance cathode sintering( 高性能陰極高性能陰極

焼結体焼結体 ).). • 　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　

• 　　　　 TRIGGER POINT BECOMES STABLETRIGGER POINT BECOMES STABLE• 　　 LITTLE DEFORMATION OF TRIGGER WAVE FORMLITTLE DEFORMATION OF TRIGGER WAVE FORM• 　　 NOISE IS HARD TO CAUSENOISE IS HARD TO CAUSE• 　　 TRIGGER LEAKAGE IS HARD TO CAUSETRIGGER LEAKAGE IS HARD TO CAUSE

CHARACTERISTICCHARACTERISTIC

SS• 3. There are a few drifts caused by the life 3. There are a few drifts caused by the life deterioration. deterioration. 4. High pressurization of the enclosure 4. High pressurization of the enclosure gas is easily possible. gas is easily possible. 5. Nesa-coat of the high heat-resistance is 5. Nesa-coat of the high heat-resistance is usedused..

PRODUCTION CAPACITYPRODUCTION CAPACITY

1 Line capacity1 Line capacity

220Kpcs/220Kpcs/MonthMonth

2 Line capacity2 Line capacity

440Kpcs/Month440Kpcs/Month

1 1 SHIFTSHIFT



2 2 SHIFTSHIFT



3 3 SHIFTSHIFT



PRESENT PRODUCTION PRESENT PRODUCTION QUANTITYQUANTITY

0

100,000

200,000

300,000

400,000

500,000

600,000

2 月 3 月 4 月 5月 6月 7月 8月 9月

国内

三新電気香港有限公司 sanshin denki hk co., ltd technical information difference of...

Documents