A F S R2001

Adaptor Part Number Code

 AVAILABLE WORLDWIDE

Easy Installation Options

Option 3 

✓  Has a pre-machined gasketing surface

  ✓  Extended nose piece fills the seal cavity and allows

the particulate to be expelled at the throat

  ✓  Removes Particulate from around the seal faces

  ✓  Requires Minimal Flush

Option 4

Option 6

  ✓  No Flange. Used to fill large cross-section of

big-bore box allowing for standard seal installation

  ✓  Removes particulate from around the seal faces

  ✓  Fills the seal cavity and allows the particulate to

be expelled at the throat

  ✓  Requires Minimal Flush

Option 2 

✓  Has a pre-machined gasketing surface

  ✓  Longer flange to allow the seal to be moved away

from any worn areas on the shaft

  ✓  Removes Particulate from around the seal faces

  ✓  Requires Minimal Flush

Option 1 Standard Configuration 

✓  Has a pre-machined gasketing surface

  ✓  Pre-machined groove for optional O-Ring

✓  Removes Particulate from around the seal faces.

✓  Requires Minimal Flush

Option 5 

✓  Has a pre-machined gasketing surface

  ✓  Extended nose piece fills the seal cavity and allows

the particulate to be expelled at the throat

  ✓  Extended front chamber to allow for cartridge seals

  ✓  Removes Particulate from around the seal faces

  ✓  Requires Minimal Flush

Note 2

Note 2

Note 2

Note 2

Note 2

Note 2

Note: 1. For no flush applications please contact EnviroSeal

  2. Also available with pre-machined gasket groove

The information contained in this bulletin is accurate at timeof print. The purchaser is responsible for ensuring thedimensions, quantity and applications suitability meetend-user requirements. Most products are "manufactured to

order "; therefore, EnviroSeal Engineering Products Ltd.retains the right to individually authorize returns based uponthe potential for resale of the products within a reasonableperiod of time.

1310 Rocky Lake Drive, WaverleyNova Scotia, Canada B2R 1R6Tel (902) 861-3464 Fax (902) 861-3522Toll Free North America Only 1-800-884-7325Website http://www.enviroseal.ca

 SpiralTrac Adaptor  F

Flush RequiredSSplit Non-Split

NNote 1

or  R Lor Drawing Number Since each device is uniquein regards to sizing, all of this

information is includedon the drawing.

ST01485-230502 Rev A

Option 7

  ✓  Has a pre-machined gasketing surface

  ✓  For use with packing

✓  Moves the packing down the shaft

  to an area with less wear,there-by prolonging

the life of the shaft / sleeve

  ✓  Requires Minimal Flush

✓ Has a pre-machined gasketing surface

✓ Extended nose piece fills the seal cavity and allows

the particulate to be expelled at the throat

✓ Removes Particulate from around the seal faces

✓ Two piece design to avoid first obstruction issues

✓ Requires Minimal Flush

Shaft Rotation

as viewed from

Motor End

ESC- PTFE

316 - 316 SS

416 - 416 SS

BRZ - Bronze

ESC

Material