日本語バージョン

Translated into Japanese by U.I.Technology

Introduction CNC-Calc v2 Tutorial 1 2D Construction

This example demonstrates one of many ways in which the 2-dimensional part above can be drawn in CNC-Calc v2. Since the part consists of a number of similar elements and since its part-elements are symmetrical only a subsection of the part needs to be drawn. The rest emerges from mirroring and finally joining the mirrored elements with straight lines completes the part. This tutorial demonstrates the use of the following functions

• Draw a rectangle with a corner radius • Draw a circle with known center and radius • Draw vertical and horizontal lines from known points • Offset a circle • Make curves between elements • Delete elements • Mirror elements about lines • Join end points with straight lines • Save file with name of your own choice

PAGE 2 OF 9

Before you start The first thing to do before drawing a new part is to set the menu parameters. Start Cimco Edit v5 and select Setup > Show Toolbars. Make sure all toolbars are displayed as shown in the image below. Toolbars can also be displayed or hidden by right-clicking on the toolbar area.

To make a new drawing you must click on CNC-Calc and then select New Drawing.

PAGE 3 OF 9

CNC Calc2 ＮＣデータ作成（ミーリング・ポケット） Ｂｙ Ｕ．Ｉ．Ｔｅｃｈｎｏｌｏｇｙ

ＤＸＦのインポートまたは図形作成

ポケット加工アイコンをクリック

加工パラメータの設定

ポケット加工ライン選択

アイコンをクリックするとツールパスが表示されます

Ｂａｃｋ ＰｌｏｔにＮｃデータを送ります。素材を設定します