jm1312-06_spc_r222.321.en-01
TRANSCRIPT
-
7/23/2019 JM1312-06_SPC_R222.321.en-01
1/12
JAWMASTER1312:06
spare parts catalog Doc. no. R 222.321 en
-
7/23/2019 JM1312-06_SPC_R222.321.en-01
2/12
This document is valid for:
Serial no. / Machine no. Sign.
JAWMASTER 1312:06
Copyright 2005 Sandvik SRP AB.
All rights reserved. No parts of this document may be reproduced or
copied in any form or by any means without written permission from
Sandvik SRP AB. All data and information in this manual may be
changed without further notice. Reservations for misprints.
Document number: R 222.321 en
Issue: 20050511
Version: 1
Sandvik Rock Processing
Stationsplan, SE-233 81 Svedala, Sweden
Tel: +46 40-40 90 00, Fax: +46 40-40 92 64
www.sandvik.com
-
7/23/2019 JM1312-06_SPC_R222.321.en-01
3/12
Spare Parts Catalog
3
JM 1312:06 Sandvik SRP AB Doc. no. R 222.321 en Ver. 1
General
Ordering information
When ordering parts, always state the machine type and serial numberaccording to the identification plate on the jaw crusher. State quantity, article
number and denomination for each ordered part.
Identification plate
The figure below shows an example of the crushers identification plate. The
identification plate contains data needed when contacting Sandvik SRP AB
concerning wear parts.
Please enter the serial number of the associated machine in the intended field
on the first page of this wear part catalog (the copyright page).
Think ahead!Avoid unnecessary downtime and increased freight charges by ordering parts
well in advance.
1 2
1 Machine type
2 Serial number
-
7/23/2019 JM1312-06_SPC_R222.321.en-01
4/12
Spare Parts Catalog
4 Sandvik SRP AB Doc. no. R 222.321 en Ver. 1
JM 1312:06
Overview
3a. 5.3b.
2.1.
4.
-
7/23/2019 JM1312-06_SPC_R222.321.en-01
5/12
Spare Parts Catalog
5
JM 1312:06 Sandvik SRP AB Doc. no. R 222.321 en Ver. 1
1. Spring retraction arrangement
Cat. no. Qty. Part number Alternative Description Remarks7000-0 2 17-106-668-001 Pin
7000-1 2 855.0017-00 Locking ring
7000-2 2 847.0142-00 Washer BRB 5392
7001-0 2 53-366-625-500 Retraction rod
7002-0 2 400.0450-001 Spring
7003-0 1 53-366-624-500 Spring guide
7004-0 1 53-366-627-500 Pressure plate
7010-1 4 00-921-203-052 Nut M6M M52
7010-2 2 847.0142-00 Washer BRB 5392
7100-0 2 53-368-317-502 Hydraulic jack
7201-0 10 840.0067-00 Screw M6S 1645
7201-2 10 847.0016-00 Washer BRB 1730
7201-3 10 845.0009-00 Nut M6M M16
7100-0
7201-0, 7201-2, 7201-3
7010-2
7004-0
7003-0
7000-0,
7000-1,
7000-2
7001-0 7002-0
7010-1
-
7/23/2019 JM1312-06_SPC_R222.321.en-01
6/12
Spare Parts Catalog
6 Sandvik SRP AB Doc. no. R 222.321 en Ver. 1
JM 1312:06
2. Toggle plate
Cat. no. Qty. Part number Alternative Description Remarks
5006-0 1 10-214-755-000 L=720 Toggle plate
10-214-535-000 L=775
5003-0 1 10-314-500-000 Toggle seat holder
5004-0 1 17-201-650-001 Toggle seat, upper
5005-0 1 17-201-650-001 Toggle seat, lower
5007-0 1 17-201-577-001 Clamping bar
5008-0 1 17-201-578-001 Dust curtain
5009-0 7 840.0045-00 Screw M6S 1230
5009-2 7 847.0147-00 Washer BRB 1324
5013-0 2 17-201-552-501 Toggle seat retainer
5014-0 4 840.0674-00 Screw M6S 24120
5014-2 8 847.0184-00 Washer 2545
5018-0 2 53-367-229-500 Side block
5005-0 5006-0
5003-0
5004-0
5013-0
5014-0, 5014-2
5007-0,
5008-0,
5009-0, 5009-2
5018-0
-
7/23/2019 JM1312-06_SPC_R222.321.en-01
7/12
Spare Parts Catalog
7
JM 1312:06 Sandvik SRP AB Doc. no. R 222.321 en Ver. 1
3a. Frame bearing assembly
Cat. no. Qty. Part number Alternative Description Remarks
2006-0 2 868.0481-00 Roller bearing Outer bearing
2006-1 2 868.0485-00 Sleeve AOH
2008-0 2 402.4199-01 Labyrinth cover
2009-0 24 840.0667-00 Screw M6S 2460
2009-2 24 847.0124-00 Washer BRB 2445
2010-0 2 400.0419-001 Labyrinth ring
2010-1 2 873.0907-00 V-ring V-450A
2011-0 2 59-425-411-001 Key
2200-0 1 400.1111-001 Eccentric shaft
2201-0 2 845.0357-00 Shaft nut HM 3068 + MS 3068
2207-0 2 59-425-421-007 Key
2208-0 2 53-467-216-000 Spacer ring
2209-1 2 845.0390-00 Shaft nut HM 52T 2604
2209-4 2 847.0300-00 Tab washer 260 MB 52
2210-0 2 53-367-215-500 Cover
2211-0 6 840.0044-00 Screw M6S 1225
2210-0 2209-42207-0
2211-0 2209-1 2208-0
2200-02008-02011-0 2010-1
2006-02006-1
2009-0,
2009-22010-0
2201-0
-
7/23/2019 JM1312-06_SPC_R222.321.en-01
8/12
Spare Parts Catalog
8 Sandvik SRP AB Doc. no. R 222.321 en Ver. 1
JM 1312:06
3b. Jaw bearing assembly
Cat. no. Qty. Part number Alternative Description Remarks
2007-0 2 402.3967-01 Labyrinth ring
2007-1 2 873.0907-00 V-ring V-450A
2101-0 2 868.0287-00 Roller bearing Inner bearing
2102-0 2 402.3301-01 Labyrinth cover
2103-0 24 840.0667-00 Screw M6S 2460
2103-2 24 847.0124-00 Washer BRB 2445
2104-0 2 402.3302-01 Labyrinth ring
2104-1 2 873.0907-00 V-ring V-450A
2007-02007-1 2102-0
2104-12104-0
2103-0,
2103-2
2101-0
-
7/23/2019 JM1312-06_SPC_R222.321.en-01
9/12
Spare Parts Catalog
9
JM 1312:06 Sandvik SRP AB Doc. no. R 222.321 en Ver. 1
4. Flywheels
Cat. no. Qty. Part number Alternative Description Remarks
2205-0 1 400.0299-001 D=2170 Flywheel flat
2206-0 1 400.0299-002 D=2170 Flywheel 105v
400.0299-003 D=2170 Flywheel 58v
400.0299-004 D=2170 Flywheel 8SPC
2212-0 1 53-366-391-001 T=10 Counterweight2213-0 2 840.0648-00 Screw M6S 2045
2213-2 2 847.0182-00 Washer DIN 137 B 20 2136
2213-5 2 847.0132-00 Washer BRB 2136
2213-0,2213-2,
2213-5
2212-0
2206-02205-0
-
7/23/2019 JM1312-06_SPC_R222.321.en-01
10/12
Spare Parts Catalog
10 Sandvik SRP AB Doc. no. R 222.321 en Ver. 1
JM 1312:06
5. Bearing housing
Cat. no. Qty. Part number Alternative Description Remarks
2000-0 1 53-173-769-500 Bearing housing, non-locating bearing
2000-1 1 10-115-285-500 Bearing housing, locating bearing
2004-0 22 840.1191-00 Screw M423190
2004-1 2 845.0397-00 Nut M6M M423
2004-2 24 847.0312-00 Washer BRB 4380
2004-7 10 53-373-766-000 Twin nut M42
2004-0,
2004-2
2004-7
2004-1
2000-1 2000-0
-
7/23/2019 JM1312-06_SPC_R222.321.en-01
11/12
-
7/23/2019 JM1312-06_SPC_R222.321.en-01
12/12