8/3/2019 Ug Voyager 510

1/8

2004 2005 Plantronics, Inc. All rights reserved. Plantronics, the logo design, Plantronics and the logo design combined, andPlantronics Voyager are trademarks or registered trademarks of Plantronics, Inc. The Bluetooth name and the Bluetooth trademarksare owned by Bluetooth SIG, Inc., and are used by Plantronics, Inc. under license. Patents U.S. 5,210,791; 6,735,453; Patents Pending.Printed in USA. 69299-05 (9.05)

www.plantronics.com

Plantronics Inc345 Encinal Street

Santa Cruz, CA 95060 USATel: (831) 426-5858

Quickstart Guide

PLANTRONICSVOYAGER 510

BLUETOOTH

HEADSET

8/3/2019 Ug Voyager 510

2/8

WELCOME2 3

FEATURES

EN This Quickstart Guide providesinstructions on the setup and usageof your Voyager 510 Mobile Headset.This product can be used as an audioaccessory for devices supportingeither the Headset or Hands-freeBluetooth Profiles.

Before getting started, pleasereview the Important SafetyInformation booklet included in yourpackage.For additional help, service, orsupport information, refer to yourproduct Warranty card, or visitwww.plantronics.com.

EN 1 Microphone

2

Call Control Button 3 Eartip

4 Listen Volume Adjust Buttons +/-

5 Power/Mute Button 6 Status Indicator Light 7 Horizontal Boom Adjustment 8 Charge Connection 9 AC Mains Charger

8/3/2019 Ug Voyager 510

3/8

CHARGING4 5

POWER ON/OFF

EN Connect the supplied wall chargerto AC power and then to yourheadset. The Status Indicator will beilluminated red while charging andchange to blue when the headset isfully charged. The headset must be

charged for a minimum of 1 hourprior to use 3 hours to fully charge.

Do not use the headset whilecharging and do not connect thecharger while the headset is inuse.

EN Press and hold the Power/MuteButton for three seconds (long press)to turn the headset on or off.

EN The Status Indicator flashes bluewhen the headset is on. When thebattery becomes low, the indicatorwill flash red.

8/3/2019 Ug Voyager 510

4/8

EN 1. Turn on both devices.2. Place the headset in pairing modeby simultaneously pressing andholding the Call Control Button andthe Listen Volume Adjust Buttonmarked + (volume up). Release the

buttons when the Status Indicatorbegins to flash red then blue.

BLUETOOTH PAIRING

BLUETOOTH6 7

BLUETOOTH PAIRING

BLUETOOTH

EN Before using your headset for the firsttime, you must pair it w ith anotherBluetooth device, such as a mobilephone. Follow the steps beginningon the next page for most dev ices.You can also refer to your phone userguide or visit www.plantronics.com.

EN Use your phones menu to search forBluetooth audio devices and selectPLT 510 when it appears on thedisplay.Note:In some circumstances thepairing process can take up to 2minutes to complete.

EN When then phone display asks fora passkey, enter: 0000. The StatusIndicator flashes blue, once theheadset is successfully paired. Ifpairing fails, try again following thesteps beginning on page 6.

If the headset stops responding

to button presses, you must resetthe headset. To reset the headset,long press (3 seconds) the MUTEand VOLUME DOWN buttonssimultaneously.

8/3/2019 Ug Voyager 510

5/8

USING YOUR HEADSET8 9

USING YOUR HEADSET

EN To answer or end a call, short press theCall Control button. (Less than 0.8 sec.)

EN To place a call using voice dialing,press and hold the Call ControlButton for 2 seconds. If you are on acall using your phone handset, youcan transfer the call to your headsetby a short press of the Call Controlbutton.

EN The following additional features maybe available if your phone supports theHands-free Profile. Not all phones supportHands-free Profile. Refer to your phoneuser guide for additional information orvisit www.plantronics.com.

Call Transfer back to phone To transfera call from your headset back to your phone,press and hold the Call Control button. You

will hear a tone. When you hear a secondtone, the transfer has been completed andyou can release the button.

Call Reject To reject a call withoutanswering when the handset is ringing,press and hold the Call Control button. Youwill hear a tone. When you hear a secondtone, the call has been rejected and you canrelease the button.

Last Number redial To redial the lastnumber, quickly press the Call Controlbutton twice. You will hear a tone on eachpress. When you hear a further tone, the lastnumber has been redialed.

S G O S G O S

8/3/2019 Ug Voyager 510

6/8

EN During a call, short press thePower/Mute Button to mute themicrophone. When muted, theheadset will sound two tones every30 seconds. To take the microphoneoff mute, press the button again.

EN Rotate the microphone horizontallyand vertically as illustrated, to selectyour left or right ear. The illustrationshows conversion from right to leftear wearing. Reverse the procedure toconvert from left to right ear wearing.

USING YOUR HEADSET10 11

FITTING YOUR HEADSET

EN During a call, press the ListenVolume Adjust Buttons to adjust thevolume.

EN Slide the headset over and behindyour ear. Then, press gently towardsyour ear for a snug fit. Adjust themicrophone position so that it isdirected towards your mouth asillustrated.

REPLACING YOUR EARTIP REGULATORY NOTICE

8/3/2019 Ug Voyager 510

7/8

REPLACING YOUR EARTIP12 13

REMOVING THE EARTIP

FITTING A NEW EARTIP

REGULATORY NOTICE

EXPOSURE TO RADIO FREQUENCY

The radiated output power of this internal wireless radio is far below the FCC radio frequencyexposure limits. Nevertheless, the wireless radio shall be used as described in the manual.

The internal wireless radio operates within guidelines found in radio frequency safety standards andrecommendations, which reflect the consensus of the scientific community.

Plantronics therefore believes the internal wireless radio is safe for use by consumers. The levelof energy emitted is far less than the electromagnetic energy emitted by wireless devices such

as mobile phones. However, the use of wireless radios may be restricted in some situations orenvironments, such as aboard airplanes. If you are unsure of restrictions, you are encouraged to askfor authorization before turning on the wireless radio.

NOTE: Modifications not expressly approved by Plantronics, Inc. could void the users authority tooperate the equipment.

REGULATORY NOTICE REGULATORY NOTICE

8/3/2019 Ug Voyager 510

8/8

REGULATORY NOTICE14 15

FCC REGISTRATION INFORMATIONThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:1. This device may not cause harmful interference; and2. This device must accept any interference received, including interference that may cause

undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protectionagainst harmful interference in a residential installation. This equipment generates, uses and canradiate radio frequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which canbe determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

REGULATORY NOTICE

ONLINE PRODUCT REGISTRATION

EN REGISTER YOUR PRODUCT ONLINE. This is not a condition of your

warranty, but will assist us inproviding the best possible serviceand technical support for yourproduct. Visit www.plantronics.com/productregistration.

www.plantronics.com/productregistration

_

CMII ID: 2005DJ0689