an naafi exports brochure

1 | P a g e

An-Naafi Exports

MANUFACTURERS OF REINFORCEMENT RODS OR DEFORMED

RODS OR COLD DRAWN STEEL WIRES OR NON ALLOY STEEL

BARS

REGISTERED OFFICE:TRANSIT CAMP,39/305,NEAR RIZVI

GARDEN ,BANDRA RECLAMATION,BANDRA WEST,MUMBAI

400 050,INDIA.

FACTORY ADDRESS:PLOT NO.608, ROAD NO.5, K.W.C.

KALAMBOLI, TAL. PANVEL. DIST. RAIGAD PIN 410208,INDIA.

PARTNERS:RAAFID KHALID SHAIKH

HUMED MEBOOBALI QURESHI

CONTACT DETAILS:00-91-9867862377/00-91-9769796794/

022-26555732

Email-id-annaafiexports@yahoo.com

Skype id-annaafiexports

2 | P a g e

Introduction AN-NAAFI EXPORTS brings certain strength, from high-rise, to highway,to high-country with quality steel products. We are INDIA’s only manufacturer of reinforcing bar and coil products, wire rod, and galvanised wire. Our products are designed to be resilient in the toughest local conditions from the sharp shock of earthquake to the slow corrosion of salt-laden air.

Coil - One continuous piece of wire as drawn in the form of a coil.

Wire -. Cold-drawn steel wire of circular cross section.

3 | P a g e

OVERVEIW OF An-Naafi

Exports

Production of 200 Tones Monthly Situated near the Port (20kms) (NHAVA SHEVA/JNPT) Raw Material procurement within 1/2kms

circumference. Stuffing Done within the Factory and directly headed

towards the PORT. Wide Factory Area with 9000sqmtrs. Pioneers in India who are making this size of 3.4mm Registered with ALL INDIA EXPORTERS

CHAMBERS,FIEO,SMALL SCALE INDUSTRY BY STATE GOVERNMENT (SSI CERTIFICATE)

4 | P a g e

5.5mm

3.5mm

Cold -drawn wire shall be supplied in the following nominal

sizes:

Diameters of Cold-drawn wire 3.5, 4.0, 4.5,4.75, 5.0, 5.3, 5.5.

The tolerance on the nominal diameter shall be +- :1or2 percent.

MANUFACTURE AND CHEMICAL COMPOSITION

Chemical Analysis Element C Mn Si S P

Min% 0.06 0.45 0.10 - -

Max% 0.10 0.60 0.22 0.045 0.045

All figures are weight percentage values

Physical Properties Nominal Diameter (mm)

Diameter (mm)

0.2% Proof Stress (MPa)

Tensile Strength (MPa)

Max. Mandrel Diameter (mm)

3.55 3.52-3.58 Min 485 575-775 3.5

4.00 3.94-4.00 Min 485 575-775 4.0

5.00 4.97-5.03 Min 485 575-775 5.0

5.5 5.54-5.66 Min 485 575-775 5.5

5 | P a g e

USE OF THE PRODUCTS

1. Beams, Girders, Foundation walls, or Floors 2. Contraction joints in Roads and Runways, and

for Column spirals. 3. Surrounding concrete and Prevent Slippage. 4. Deform mesh 5. Most cost-effective option for construction and

repair of roads, bridges, and large industrial

plants.

6. Protect the land from erosion, used for fence

and frame construction.

6 | P a g e

Today, it is impossible that a modern building is without reinforcement Mesh

or Bar or Rods

AN-NAAFI EXPORTS