根據《電訊條例》(第 106 章)第 7c條更改短程器件 …....
Post on 18-May-2018
238 Views
Preview:
TRANSCRIPT
-
- 1 -
106 7C
500
(MHz)
2.
106 7C(1) 7C(2)
1
3.
4. 7C(1)
7C(2)
(a)
1 433 434.79
-
- 2 -
(b)
(c)
(d)
5. 7C(4)
(a)
(b)
(c)
(d)
(e)
6.
/
2743360(GHz)
79
7.
2 3.1 10.6
3.4 4.2
2 http://tel_archives.ofca.gov.hk/zh/report-paper-guide/paper/consultation/20090320.pdf
http://tel_archives.ofca.gov.hk/zh/report-paper-guide/paper/consultation/20090320.pdf
-
- 3 -
8.
3
3.1 10.6
18
9. IEEE
IEEE 802.15.4
1 10
IEEE 802.15.4 16
1 14 3.1 4.8 11
6 10 500
( 4.2 4.8)( 7.7 8.3)
10. EN 302 065
(EN 302 065-1)(EN 302 065-2)(EN 302
065-3)(EN 302 065-4)(EN 302 065-5)
FCC
FCC 15 FFCC 15F
11.
3 http://tel_archives.ofca.gov.hk/zh/tas/others/tas20100330.pdf
http://tel_archives.ofca.gov.hk/zh/tas/others/tas20100330.pdf
-
- 4 -
12.
13.
RFID
7C(1)
433 434.79 RFID
433 434.79
433
14.
15. 433
433
16. 7C(1) 7C(2)
(a) 433
(b) 433
-
- 5 -
17. 3.1 10.6
10
4.2 4.8 6 8.5
IEEE
4.2 4.86 8.5
18. 4.2 4.8 6 8.5
-41.3 dBm/MHzEIRP
4.2 4.8
4 -70 dBm/MHz -41.3 dBm/MHz
EIRPEN 302 065FCC15F4.2
4.8 6 8.5
EN 302 065
-41.3 dBm/MHz EIRP
4.2 4.8 6
8.5-41.3 dBm/MHz EIRP
19
HKCA
19.
HKCA 1080
EN 302 065-1 Short Range Devices (SRD) using Ultra Wide
Band technology (UWB); Harmonised Standard
covering the essential requirements of article 3.2
of the Directive 2014/53/EU; Part 1:
Requirements for Generic UWB applications
4
-
- 6 -
EN 302 065-2 Short Range Devices (SRD) using Ultra Wide
Band technology (UWB); Harmonised Standard
covering the essential requirements of article 3.2
of the Directive 2014/53/EU; Part 2:
Requirements for UWB location tracking
EN 302 065-3 Short Range Devices (SRD) using Ultra Wide
Band technology (UWB); Harmonised Standard
covering the essential requirements of article 3.2
of the Directive 2014/53/EU; Part 3:
Requirements for UWB devices for ground
based vehicular applications
EN 302 065-4 Short Range Devices (SRD) using Ultra Wide
Band technology (UWB); Harmonised Standard
covering the essential requirements of article 3.2
of the Directive 2014/53/EU; Part 4: Material
Sensing devices using UWB technology below
10.6 GHz
47 1
15 F
20.
1
4.2 4.8 6 8.5 433 434.79
(a) 433
(b) 433
-
- 7 -
(c) HKCA 1080
4.2 4.8 6 8.5
2
21. 7C(4)
HKCA 1080
22.
213
29
1
2803 5112
spenq@ofca.gov.hk
mailto:spenq@ofca.gov.hk
-
1
106
1067(5)7B(2)
[ ][ ]
1.
1.1
616 3 5
1
2
106
1 25
1
-
2
1.2
1.3
2.
2.1
3.
3.1
3.2
3.3
4.
4.1
-
3
4.2
4.3
5.
5.1
5.2 5.1
5.3
5.4
6.
6.1
-
4
I II
32DHKTA 1061
32D
I
433.00 434.79
10 mW
HKCA 1061 433
II
4.2 4.8
6 8.5
-41.3 dBm/MHz
HKCA 1080 4.2 4.8 6 8.5
-
D R A F T HKCA 1080
ISSUE 1
[ Date ]
[ ]
4.2 4.8/6 8.5
PERFORMANCE SPECIFICATION FOR
SHORT RANGE DEVICES
OPERATING IN THE 4.2 4.8 GHz
AND/OR 6 8.5 GHz BANDS
EMPLOYING ULTRA-WIDEBAND
TECHNOLOGY
2
-
HKCA1080 ISSUE 1 PAGE i
[ Date ]
FOREWORD
1. This specification is prescribed under section 32D of the Telecommunications
Ordinance (Cap 106) (the Ordinance) to set out set out the technical requirements
for Short Range Devices (SRD) operating in the 4.2 - 4.8 GHz and/or 6 - 8.5 GHz
bands employing ultra-wideaband technology. Radiocommunications apparatus falling
into the scope of this specification shall meet the stipulated requirements.
2. Under the Ordinance, the possession or use of any radiocommunications apparatus or
any apparatus emitting radio frequency energy must be covered by an appropriate
licence issued by the Communications Authority (CA) with the exception of those
specifically exempted from licensing under the Ordinance, such as those covered by
the Telecommunications (Telecommunications Apparatus)(Exemption from
Licensing) Order.
3. At present, the Office of the Communications Authority (OFCA) operates a Hong
Kong Telecommunications Equipment Evaluation and Certification (HKTEC)
Scheme. Details of the HKTEC Scheme can be found in the information note OFCA I
421. Under the Scheme, suppliers or manufacturers of the radiocommunications
apparatus may apply for certification of their apparatus against this specification. The
application procedures for certification of radiocommunications apparatus can be
found in the information note OFCA I 401. A prescribed label may be affixed to the
certified equipment. Details of the labelling arrangement can be found in the
Standardisation Guide HKCA 3211.
4. The CA may amend any part of this specification as and when it deems necessary.
5. In case of doubt about the interpretation of this specification, the methods of carrying
out the test and the validity of statements made by the equipment manufacturers or
suppliers about the equipment, the decision of the CA shall be final.
6. The HKCA specifications and information notes issued by the CA can be downloaded
from OFCAs website at http://www.ofca.gov.hk. Enquiries about this specification
may be directed to:
Senior Telecommunications Engineer
Standards Section
Office of the Communications Authority
29/F Wu Chung House
213 Queens Road East
Wanchai
Hong Kong
Fax : +852 2838 5004
Email : standards@ofca.gov.hk
http://www.ofca.gov.hk/mailto:standards@ofca.gov.hk
-
HKCA1080 ISSUE 1 PAGE ii
[ Date ]
AMENDMENT HISTORY
Item Issue No. Paragraph Descriptions
1. Issue 1
[ Date ]
All First release
-
HKCA1080 ISSUE 1 PAGE iii
[ Date ]
CONTENTS
1. Scope of Specification
2 Electrical Safety Requirements
3 Technical Requirments
4 Evaluation Requirements
5 Reference
-
HKCA1080 ISSUE 1 PAGE 1
[ Date ]
1. SCOPE OF SPECIFICATION
This specification defines the minimum performance requirements for Short Range
Devices (SRD) operating in the 4.2 4.8 GHz and/or 6 8.5 GHz frequency bands
employing ultra-wideband technology (hereafter referred to as the equipment).
2. ELECTRICAL SAFETY REQUIREMENTS
If the equipment is for connection to the public telecommunications networks, it shall
comply with the electrical safety requirements set out in HKCA 2001 Compliance
Test Specification - Safety and Electrical Protection Requirements for Subscriber
Telecommunications Equipment issued by the Communications Authority (CA).
3. TECHNICAL REQUIREMENTS
3.1 The equipment shall meet the following technical requirements:
(a) Frequency bands: 4.2 4.8 GHz and/or
6 8.5 GHz
(b) Maximum mean spectral
power density (e.i.r.p.):
41.3 dBm/MHz
3.2 The equipment shall meet the technical requirements in accordance with the
appropriate standard in the following list:
(i) ETSI EN 302 065-1 Short Range Devices (SRD) using Ultra Wide Band
technology (UWB); Harmonised Standard covering the essential
requirements of article 3.2 of the Directive 2014/53/EU; Part 1:
Requirements for Generic UWB applications
(ii) ETSI EN 302 065-2 Short Range Devices (SRD) using Ultra Wide Band
technology (UWB); Harmonised Standard covering the essential
requirements of article 3.2 of the Directive 2014/53/EU; Part 2:
Requirements for UWB location tracking
(iii) ETSI EN 302 065-3 Short Range Devices (SRD) using Ultra Wide Band
technology (UWB); Harmonised Standard covering the essential
requirements of article 3.2 of the Directive 2014/53/EU; Part 3:
Requirements for UWB devices for ground based vehicular applications
(iv) ETSI EN 302 065-4 Short Range Devices (SRD) using Ultra Wide Band
technology (UWB); Harmonised Standard covering the essential
requirements of article 3.2 of the Directive 2014/53/EU; Part 4: Material
Sensing devices using UWB technology below 10.6 GHz
-
HKCA1080 ISSUE 1 PAGE 2
[ Date ]
(v) Code of Federal Regulations (USA); Title 47 Telecommunication; Chapter 1
Federal Communications Commission, Part 15 Radio Frequency Devices:
Subpart F Ultra-Wideband Operation
4. EVALUATION REQUIREMENTS
Compliance of the equipment with the technical requirements shall be evaluated in
accordance with the procedures specified in any one of the standards stated in clause
3.2.
5. REFERENCE
(i) ETSI EN 302 065-1 Short Range Devices (SRD) using Ultra Wide Band
technology (UWB); Harmonised Standard covering the essential
requirements of article 3.2 of the Directive 2014/53/EU; Part 1:
Requirements for Generic UWB applications
(ii) ETSI EN 302 065-2 Short Range Devices (SRD) using Ultra Wide Band
technology (UWB); Harmonised Standard covering the essential
requirements of article 3.2 of the Directive 2014/53/EU; Part 2:
Requirements for UWB location tracking
(iii) ETSI EN 302 065-3 Short Range Devices (SRD) using Ultra Wide Band
technology (UWB); Harmonised Standard covering the essential
requirements of article 3.2 of the Directive 2014/53/EU; Part 3:
Requirements for UWB devices for ground based vehicular applications
(iv) ETSI EN 302 065-4 Short Range Devices (SRD) using Ultra Wide Band
technology (UWB); Harmonised Standard covering the essential
requirements of article 3.2 of the Directive 2014/53/EU; Part 4: Material
Sensing devices using UWB technology below 10.6 GHz
(v) Code of Federal Regulations (USA); Title 47 Telecommunication; Chapter 1
Federal Communications Commission, Part 15 Radio Frequency Devices:
Subpart F Ultra-Wideband Operation
- END -
top related