frontier pro insert фильтр
TRANSCRIPT
-
8/8/2019 Frontier Pro insert
1/1
MULTI-USE EMERGENCY WATER FILTER SYSTEM
FILTERSUPT
O
50GALLONS
(190 L)
3
1
2
Use the Frontier Pro lter to lter water directly rom any water bottle,cup, hydration system or directly rom any water source. The Frontier Pro
lter is tested and certied to remove >99.9% o Giardia, Cryptosporid-
ium. Activated Carbon helps reduce waterborne chemicals and improves
the taste o ltered water. Miraguard antimicrobial technology sup-
presses the growth o bacteria, algae, ungus, mold and mildew within the lter media.
Easy to UsE1) On initial use attach lter to water container.
2) Pull on cap strap and position the cap to the side o the
lter.
3) Pinch Bite Me Valve between thumb and orenger
and squeeze water container to orce water through the
lter and out the valve. When the water stream is clear,
bite on valve and suck water through the lter.
Ne: Flow rates may be slightly reduced and suction a little
dicult, on initial use due to entrapped air in the lter matrix.
Flow rates will improve as the lter media becomes thoroughly
wetted.
t Remve/Replce Prefler Dik:
1) Screw of prelter adapter rom the base o the lter
casing (Fig 1).
2) Pull the prelter disk out o the adapter cup (Fig 2).
3) Place a new prelter disk into the adapter cup
(Fig 3).
4) Screw the prelter adapter snuggly onto the base othe lter casing.
t Remve/Replce Bie Me vlve:
1) While holding the lter with one hand, grab the base
o the bite valve with your other hand. Twist and pull
the valve straight of. (Fig. 4)
2) To replace Bite Me Valve, press the core insert into
the boss until it bottoms out on the rim o the boss.
3) Wet the inside surace o the sheath and press it over
the insert and boss until it bottoms out at the base o
the boss.
4) Position the sealing rim o the sheath so that the
button protrudes slightly above the rim o thesheath. (Fig. 5)
t se up Grvi Flw Drip sem:
1) Remove the Bite Me valve.
2) Attach Frontier Pro to reservoir.
3) Hang the reservoir with the lter at the lowest
point and allow gravity to orce waterthrough the lter. (Fig. 6)
4) Increased distance between the reservoir and the
lter will improve drip rate.
t re fler r exended perid:
1) Remove and discard the prelter disk.
2) Remove cap and Bite Me valve sheath
3) Allow to air dry at room temp. (Min. 48 hours)
4) Insert a new prelter disk prior to next use.
Ne: For maximum protection, use the Frontier Pro in
conjunction with aqumir Wer tremen or
aqumir Wer Purifer tble.
DO NOT FREEZE. Freezing a wetted lter may damage
the lter media and compromise lter integrity.
Fig 3
Fig 2
Fig 1 Unscrew
Remove
Filter
Replace
Filter
Fig 4Pull and
twist on
sheath to
remove
Fig 5
Fig 6
Position sheath
so that the but-
ton is visible as
shown.
Use longer
tube rom
water bag
to flter or
improved
drip rate.
card # 015007