pyisoe

Upload: pyi-soe

Post on 03-Jun-2018

217 views

Category:

Documents


0 download

TRANSCRIPT

  • 8/12/2019 pyisoe

    1/2

    E001-002ADDITIONAL FUNCTIONS>2 KEY>8 KEY> ADDITIONAL FUNCTIONS>#CLEAR>ENGINE>ERRCLR.After performing the Engine error Clear in Service Mode, the copier should bootand performed normally.Note: This mode below should be used to clear all Fixing related Error Codes.Enter service mode by pressing additional functions than 2 than 8 and then Additional Functions. #SSSW will be displayed.1-Use the right arrow and scroll to #CLEAR then press OK.2-Use the right arrow and scroll to ENGINE then press OK.ERRCLR will be displayed then press OK.Then power cycle the machine..........................................erroe code E000003 of ir canon copier 2520Press the additionel function button & press 2&8 buttons at once and again pressadditionel function .select COPIER and FUNCTION and CLEAR and ERROR andpress OKbutton..........................................Canon IR 2520i error code E000002This code is a fuser error code. First try and clear the error in service mode -this may help you for a long or short time depending upon the severity and cause of the problem. There may have been a jam in the fuser affecting the temperature. Press the head key (the head shape key with an asterick inside) the the number '2' and '8' at the same time, then the head key again quickly. Then press 'FUNCTION' then 'CLEAR' from the next screen - and then press 'ERROR' then 'OK'. No

    w, switch the machine off for 10 seconds and then back on. If your problem is not so serious then the error will be gone with perhaps only a jam remaining. If not, then you will require a new fixing film unit...........................................Fix error E000001e001 is a fuser error. it might be able to be reset, but should be looked by a tech.

    SERVICE MODE*28*-press the additional func button, 2&8 at the same time, and the additionalfunc button again.when you have done it correctly, the screen will change and it will say servicemode across the top.

    Then select:copierfuncclearerrpress the done or ok button on the lower right side of the screen.turn the machine off at the black switch on the right side, wait 10secs, turn back on. should work.****DONT MESS WITH ANYTHING ELSE IN SERVICE MODE YOU CAN REALLY SCREW UP THE MACHINE.!!!!!!!!!!!!!!!******************..............................................canon ir 2520 error code E000020E020 0000

    The path between the sub hopper and the developingassembly is clogged with toner.

    1.Check the rotation of hopper motor gear. (If rotating, falsedetection by the sensor is doubted. Feed the toner to thedeveloping unit in service mode: CLEAR>ENGIN>TNRINST.)2.Replace the Developing Assembly Toner Sensor (TS1).3.Replace the Sub Hopper Toner Sensor (TS2).4.Replace the DC Controller PCB (PCB4).

  • 8/12/2019 pyisoe

    2/2

    SERVICE MODE:* 28 * or MENU and #